42114101 Rev.1 66 /3.3.9 Carriage Cable(1) Remove the printhead (see 3.3.1).(2) Remove the upper cover (see 3.3.4 (1) – (5)).(3) Remove the gear case Assy (see 3.3.5).(4) Remove the space motor (see 3.3.7).(5) Remove the space rack (3.3.8).(6) Remove two screws 1, release the Control Board 2 and PCB sheet 9 by lifting clamp8, and disconnect cable from connector 3, 4, 5, 6.(7) Remove carriage cable 7 from fasteners on frame.(8) To install, follow the removal steps in the reverse order.Note on installation:(1) Take care not to fold the carriage cable 7 during installation. Curve slightly thecarriage cable 7 when assembling into the fasteners.(2) Make sure that the paper end lever A will not contact the Paper end Sensor 0 whenmounting the Control Board.(3) Make sure that there is not any dust or oil on the connector contact sections A toD. If it is found, wipe it off by alcohol.0 A72Claw ClawABCD7863492514
