Oki TF-300P Field Service Manual

Contents

5-9with a cross straight screwdriver.(3) Loosen 2 pieces of M3X12 tapping cap screw(with a Spring Washer on right side screw) onright and left side of Base Frame Unit with a cross straight screwdriver then Paper FeederUnit and Base Frame Unit can be separated.5.3.15 Paper Feeder UnitFigure 5-9 Paper Feeder Unit(1) Ground Spring & Ground WireLoosen 1 piece of M3X6 tapping cap screw on Handle side by cross screwdriver thenGround Spring and Ground Wire can be taken out from Paper Feeder Unit.(2) Pick Up Roller Clutch & E-ringFace the Gear-Pick Up side of Paper Feeder Unit. Release the E- ring (£ X4 )on the outsideof gear by straight screwdriver then take out Pick Up Roller Clutch and E-ring.(3) E-ringRelease the E- ring (£ X4) on the both side of Paper Feeder Unit by straight screwdriverthen take out E-ring.(4) Sintering BearingMove outward two Sintering Bearing then take them out.(5) Pick Up Roller Asm.Remove Pick Up Roller Asm. leftward then upward. Pick Up Roller Asm. can be taken outfrom Paper Feeder Unit.(6) Handle & Spring-HandleFace the Handle side of the Paper Feeder Unit. Loosen 1 piece of M3X6 taptite cap screwby cross screwdriver then it and Spring-Handle can be taken out.(7) Spring-Buckle CornerTake out Spring-Buckle Corner by hook.(8) Buckle CornerFace the Plane-Knock Up. Pull Buckle Corner up and outward then it can be taken out.(9) Plate –Knock UpHold left side of Frame-AFP by left hand. Wrench left side of Plate-Knock up by thumb ofright hand then fixed position pin of Plate-Knock Up will be taken out. Face the rear ofFrame-APF, release the snap of Plate-Knock Up from Linkage then Plate-Knock Up can betaken out from Frame-APF.(10) Paper Support