Olivetti JP 90 User Manual

Also see for JP 90: Service manual

Contents

Olivetti JP 90 User Manual Manual pdf 20 page image

Connecting the AC/DC AdapterThe AC/DC adapter (item B on page III) serves as the powersupply for your printer when you are working in an officeenvironment.As the AC/DC adapter is powered as soon as it is con-nected to the electrical power supply, make sure that it isNOT plugged into the power supply socket whenconnecting its jack to the printer.Make sure that the voltage indicated on the electrical dataplate on the base of the AC/DC adapter corresponds to that ofyour electrical power supply.If the voltage indicated is not that supplied, call your localretailer immediately. DO NOT, UNDER ANY CIRCUMSTANCES,CONNECT THE AC/DC ADAPTER.Make sure that the plug on the power cable of the AC/DCadapter is of the type accepted by the power socket you intendto use; if it is not, call your local retailer. Do NOT attempt tochange the plug yourself.The manufacturer declines all responsibility for accidents tope r s ons o r da mag e to the p r int er arising from thenon-observance of this warning.• Place the printer and the AC/DC adapter on a flat surface.• Plug the AC/DC connector jack into the socket markedDC-IN on the rear of the printer (see figure on page V).• Insert the plug of the AC/DC adapter in the power socketInstead of the AC/DC adapter, your can use 10 marketstandard LR6/AA type batteries (see figure on page V), oreither of the optional battery packs (item 1 on page IV)available (see “Using Batteries” in the User Guide).Switching on the Printer• Press the POWER key on the operator panel to switch onthe printer.The light indicators on the operator panel flash once insequence, and the POWER light indicator remains lit.Whenever you switch on the printer, it undergoes a series ofinternal checks and a mechanical reset is executed (a slightnoise is audible).Inserting the Print HeadSee the sequence of figures on page VI and theinstruction template on the inside of the front cover.• Open the sealed print head container (item C on page III)and remove the print head, holding it by the casing (theend opposite the protective film).• Still holding the print head casing, remove the protectivefilm.Do not touch the electrical contacts or the printingnozzles nor sit the print head on either of them.• With the printer already powered, press the CARTRIDGEkey on the operator panel to move the print head carriageto the head loading position.2 Quick Start