Olivetti d-Color MF2001 Service Manual

Also see for d-Color MF2001: Sales guide Installation manual

2KZ/2K01-3-76U411 Adjusting the scanner automaticallyDescriptionUses a specified original and automatically adjusts the following items in the scanner and the DPscanning sections.Scanner section: Original size magnification, leading edge timing, center line, input gamma, inputgamma in monochrome mode and matrixDP scanning section: Original size magnification, leading edge timing, center linePurposeTo perform automatic adjustment of various items in the scanner and the DP scanning sections.Method1. Press the start key.2. Select the item.Method: TableTo manually enter the target value1. Enter the target values which are shown on the specified original (P/N: AVGR14938B) execut-ing maintenance item U425.2. Set a specified original (P/N: AVGR14938B) on the platen.3. Enter maintenance item U411.4. Select [Target].5. Select [U425] using the cursor left/right keys.6. Select [Table].7. Press the start key. Auto adjustment starts.To manually enter the target valueThe accuracy of adjustment is worse than the manual entry.1. Set a specified original (P/N: AVGR14938B) on the platen.2. Enter maintenance item U411.3. Select [Target].4. Select [Auto] using the cursor left/right keys.5. Select [Table].6. Press the start key. Auto adjustment starts.* : When automatic adjustment has normally completed, [OK] is displayed. If a problemoccurs during auto adjustment, [NG XX] (XX is replaced by an error code) is displayedand operation stops. Should this happen, determine the details of the problem and repeatthe procedure from the beginning.Item No. DescriptionDisplay Description Original to be usedfor adjustment (P/N)Table Automatic adjustment in the scanner sec-tionAVGR14938BDP Automatic adjustment in the DP scanningsection:AVGR12924QAll Performs automatic adjustment in the DPscanning section following automaticadjustment in the scanner sectionAVGR14938B/AVGR12924QTarget Set-up for obtaining the target value -Service Manual Y113010-4