Direct printing (PictBridge)12210Printing picturesIf an error message is displayed on the camera’s monitor during direct print settingor printing, see the following table.For more details, refer to the printer’s instruction manual.If an error message is displayedMonitor indication Possible cause Corrective actionNO CONNECTIONThe camera is notconnected to the printercorrectly.Disconnect the camera andconnect it again correctly._DOCK&DONEPRINTER IS NOTCONNECTED[_PRINT ORDER] wasselected, but the camerawas not connected to aDock&Done printer.If [_PRINT ORDER] is seton the [PC/PRINTER]screen, connect to aDock&Done printer.NO PAPERThere is no paper in theprinter.Load some paper in theprinter.NO INKThe printer has run out ofink.Replace the ink cartridge inthe printer.JAMMEDThe paper is jammed. Remove the jammed paper.SETTINGS CHANGEDThe printer’s paper tray hasbeen removed or the printerhas been operated whilechanging settings on thecamera.Do not operate the printerwhile changing settings onthe camera.PRINT ERRORThere is a problem with theprinter and/or camera.Turn off the camera andprinter. Check the printer andremedy any problems beforeturning the power on again.TIPS• If an error message other than those shown above is displayed, see “Errormessages” (P. 145).