13En1 Press 2Y.2 Press 12 to select [Y12 SEC] or [Y2SEC], and press o.3 Press the shutter button completely to takethe picture.1 Press#(Flash pop-up) to open the flash.2 Press 3#. Press 12 to select the flash mode, and press o.3 Press the shutter button halfway.When the flash is set to fire, the # mark lights.4 Press the shutter button completely to take the picture.To save battery power, the camera automatically enters sleep modeand stops operating if not used for 3 minutes in shooting mode. Pressthe shutter button or turn the zoom lever to reactivate the camera.If the camera is not operated for 12 minutes after the camera enterssleep mode, it automatically retracts the lens and turns off. To resumeoperation, turn on the power again.Y12 SEC The self-timer lamp lights forapproximately 10 seconds, thenstarts blinking.After blinking for approximately 2seconds, the picture is taken.Y2 SEC The self-timer lamp blinks for 2seconds, then the picture istaken.Icon Flash Mode DescriptionAUTO Auto flash The flash fires automatically in low light or backlightcondition.! Red-eyereduction flashEmits pre-flashes for red-eye reduction.# Fill-in flash The flash fires regardless of the available light.H Red-eye fill-inflashThe flash always fires after pre-flashes for red-eyereduction are emitted.#SLOW Slow flash The flash fires with slow speed.$ Flash off The flash does not fire even in low light conditions.Self-TimerSelf-Timer LampFlash ModesPower Save Feature