Omitec OmiSmoke Operating Instructions Manual
                                                  | |
Contents
| 
Test Procedures24Reduced Pollution Certificate (RPC) - (Category B only)The RPC menu is only shown if category B has been selected previously. Select RPC1, 2, 3, 4 or No RPC for standard MOT tests. RPC limits for 1, 2, 3 and 4 are explainedin relevant RPC test instruction manual.Oil Temperature Measurement (Category A only)This selection ‘Measure Oil Temp’ will only appear on Category A tests. The MOTFAS test prefers that Oil Temperature is measured.Press the tick key for YES.Follow the instructions given in section ‘Engine Oil Temperature Sensor Probe’paying particular attention to the use of the probe and the relevant warnings.WARNING: Incorrect use may result in damage to both user and vehicle.The minimum oil temperature required for the test to proceed is 60°C, however theuser has the option to wait for a higher temperature before proceeding. Once oiltemperature is recorded the user is prompted to remove the probe, replace thedipstick and confirm this before the test will continue.WARNING: Do not rev/accelerate the engine with the temperature probeinserted into sump as increased vibration may cause it to move and causedamage. |
Related manuals for Omitec OmiSmoke
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine