PAC Automobile Accessories Installation Instructions Manual

Contents

06-14-07SWI-JACKUniversal Steering Wheel Control InterfaceBefore You StartA. Is this product compatible with the vehicle?• See application guide (separate sheet) for listing of vehicles and connection information. If not, please visithttp://www.pac-audio.com/swixprogramming/swixprogramming.asp for the most current list of compatiblevehicles.B. Prepare for the installation.• If possible, install the SWI-JACK while you are installing the new head unit. Keep in mind you may need to plug inthe factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-JACK isworking properly.• Plan a general installation location for both the SWI-JACK plug and the control body. Keep in mind that the sup-plied wire harness is two feet long, and the 1/8" plug harness is three feet long.• Use a multimeter or approved measuring device for checking vehicle circuits.Pacific Accessory CorporationSEEKPRESET AM FMVOLUMEPLAY MUTEPowerJack for the SWI-JACKSteering wheelaudio control wireTo Kenwood wiredremote control inputInstallation InstructionsFor Alpine, JVC, Clarion andKenwood OEM Steering RemoteReady RadiosFor Alpine, Clarion or JVC radios, connect the SWI-JACK 1/8" plug into the radio's Steering Wheel input jack onback of radio or wire harness. For Kenwood radios, connect the blue/yel wire to the Remote Input wire (blue/yel) of radio.Blaupunkt radios with optional wireless remote inputs are supported by the SWI-JACK, however we do notsupply any connectors or support for Blaupunkt. It is up to the consumer or installer to supply this connector. Usevehicle Connector Chart and use VW connector as reference. Connect the SWI-JACK's blue/yel wire to pin #11 of VWconnector. The connector you obtain may come with two of three pieces, however the connector (usually green) shouldshow pin #11 on it.