Panasonic 1735 Technical Description

Also see for 1735: Specification sheet

Panasonic Electric Works Nordic ABMEW01295 Rev: 2 Technical Description Alert Annunciation Units 1735 & 1736, ver. 1.4.x15Table of push buttons:Push button Colour Operation / functionP1 (Depending onlanguage, etc."Alarms queued")Black Used, when LED "L2" is turned on, to scrollthrough the queued alarms. (The first alarm willautomatically be shown again after 20 seconds, ifno button is used during that time.)P2 (Depending onlanguage, etc."Acknowledge")Yellow Used to acknowledge an AA alarm. The unit'sbuzzer will also be silenced. (Investigation timestarts.) Acknowledged AA alarm is indicated byLED "L4".P3 (Depending onlanguage, etc."Silence alarm devices")Red Used to silence the alarm devices.(Normal fire alarms & AA alarms.) 12P4 (Depending onlanguage, etc."Reset")Green Used to reset all AA alarm(s). (Fire alarms, i.e.not AA alarms, have to be reset in the c.i.e.). Socalled "encapsulation" is not possible to do.P5 (Depending onlanguage, etc.("Test")13White Used for testing the LEDs, the buzzer and thedisplay (back-light and dots). NOTE! This mustbe done only in quiescent condition.NOTE! Regarding "P1" and "P2", see chapter "SW mode & Addresssetting, page 16 and regarding "P3", chapter "SW version", page 27.Table of others:Component IndicatingBuzzer14 1 beep/5 s AA alarm.Cont. + All LEDsturned off as well.There is a CPU / memory fault in the unit.Display All or selected Fire alarms / AA alarms presented like in thec.i.e. that the AA unit is connected to and an alarm text (ifprogrammed). (NOTE! A fault message may be shown,indicating a communication fault (i.e. no connection betweenthe unit and the c.i.e.).NOTE! Regarding the Buzzer and the Display, see also chapter "SWmode & Address setting, page 16.12 If the "Silence alarm devices" button in the c.i.e. has been programmed to"Disable alarm devices", "P3" will have the same function. "P3" cannot beused until a fire or AA alarm is activated in the system.13 Press "P5" (Test) for a test of the LEDs, the buzzer and the display (back-light and dots). NOTE! This must be done only in quiescent condition.14 The buzzer may be programmed as "disabled" (via Win512 / Win128 /Win512 G3), i.e. it will never sound.