Panasonic 9TGCF-P13 Operating Instructions Manual

3For U.S.A.Federal Communications Commission Radio Frequency InterferenceStatementNote: This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance withthe instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turn-ing the equipment off and on, the user is encouraged to try to correct the interference by oneor more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.Consult the Panasonic Service Center or an experienced radio/TV technician for help.WarningTo assure continued compliance, use only shielded interface cables when connecting to acomputer or peripheral. Also, any changes or modifications not expressly approved by theparty responsible for compliance could void the user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may causeundesired operation.Responsible Party: Matsushita Electric Corporation of AmericaOne Panasonic WaySecaucus, NJ 07094Tel No:1-800-LAPTOP-5 (1-800-527-8675)Read Me FirstNotice for the products using LCDThis product uses one or more fluorescent lamps containing a small amount of mercury. It alsocontains lead in some components. Disposal of these materials may be regulated in yourcommunity due to environmental considerations. For disposal or recycling information pleasecontact your local authorities, or the Electronics Industries Alliance: