Panasonic 9TGCF-P13 Operating Instructions Manual

41DisplayThe LCD backlight may have automatically turned offdue to the power-saving function. Turn on the LCD back-light by holding down the power switch until the back-light goes on.Adjust the backlight brightness.1 Tap - [Settings] - [System] tab - [Backlight].2 Tap the [Brightness] tab and adjust the brightness withthe slider.Push the reset switch to restart.Align the screen ( page 20).It is hard to view the LCD.The cursor cannot be con-trolled.The cursor does not prop-erly correspond to a stylustap.A host computer does notrecognize CF-P1.Confirm that Microsoft®ActiveSync® 3.7 (or a later ver-sion) has been installed in the host computer.Check to see if a fully charged battery pack is properlyinstalled to CF-P1.If a modem card has been inserted, disconnect these de-vices and check the communication status again.Confirm that CF-P1’s power is on.Push the reset switch to restart.If a cable or cradle is being used for the connection,recheck the connection to the host computer.Peripheral is not recog-nized even after driver isinstalled.Connecting a Host PCConnecting PeripheralsRemove cards or other peripherals, and push thereset switch.Application SoftwareConnect the AC adaptor and push the reset switch. Checkthe remaining battery level and make sure that multipleapplications are not running simultaneously. Close allapplications that are not being used.The computer locks up dur-ing the execution of an ap-plication, or the executionspeed becomes noticeablyslower.Cannot connect to the net-work.Check the server information and network settings.Network