Panasonic AE3000U - LCD Projector - HD 1080p Operating Instructions Manual

Contents

Panasonic AE3000U - LCD Projector - HD 1080p Operating Instructions Manual Manual pdf 24 page image

Basic OperationRemote control operation24 - ENGLISHYou can access saved settings instantly. See“MEMORY LOAD” on page 36.1. Select the required setting from MEMORY1 - 16.Undefined setting will not be displayed.2. Press the ENTER button to activate the selectedsetting.The aspect ratio will be selected automatically,or you can switch it manually by pressing theASPECT button. Press the button severaltimes to cycle through the different aspect typeas follows. See “ASPECT” on page 37.Q VIDEO/S-VIDEO/COMPONENT (YPBP R)Q COMPUTER (RGB)Q HDMIYou can display the image brightness andcontrast level of the input signal with awaveform. See “WAVEFORM MONITOR” onpage 33.J Displaying the waveform1. Press the WAVEFORM button and display thewaveform monitor.Press the WAVEFORM button again to escape fromthe waveform mode.2. Press ENTER button until the required waveformoption is displayed.In FULL SCAN mode, press F G I H to changethe waveform position.In SINGLE LINE SCAN mode, press F G to selectthe required line position.Loading a saved settingNOTE:• If you have not saved any settings, MEMORY1 - 16 willnot be displayed.Switching the aspect ratio4:3 JUST16:9 ZOOM214:9 ZOOM14:3 16:94:3 16:9NOTE:• If you project an image with an unmatched aspect ratio,the image may distort or some portions may becropped. Select an aspect ratio which preserves theintention of the image creator.• The order of aspect type is defined not only by the inputmethod but also by the input signals. See “List ofcompatible signals” on page 50.• If you project a copyrighted image enlarged or distortedby using ASPECT function in commercial use in apublic place, such as a restaurant or hotel, you mightinfringe on the copyright of the creator which isprotected by copyright law.Adjusting the signal condition with a waveformFULL SCANMonitoring the waveform ofbrightness and contrast of the wholeimage.SINGLE LINE SCANMonitoring the waveform ofbrightness and contrast in eachhorizontal line of the image.FULL SCAN(Y) SINGLE LINE SCAN(B)FULL SCAN(R) SINGLE LINE SCAN(G)FULL SCAN(G) SINGLE LINE SCAN(R)FULL SCAN(B) SINGLE LINE SCAN(Y)NOTE:• In SINGLE LINE SCAN mode, the position of the waveform monitor depends on the position of the selected line.• You can display the main menu by pressing the MENU button and adjust the menu items.• The called up menu items displayed position depends on the position of the waveform monitor.• You can activate AUTO ADJUST of the WAVEFORM menu by pressing the DEFAULT button.• The signal which is lower than 0% in the waveform will be displayed as same as 0% on the projected image.• While the waveform is displayed, the image is displayed without the COLOR MANAGEMENT adjustment.• When adjusting the KEYSTONE of the POSITION menu while the waveform is displayed, x.v.Color will be deactivated.