Panasonic AG-DVX100A Operating Manual

Also see for AG-DVX100A - Pro 3-CCD MiniDV Proline Camcorder: Menu information Brochure & specs Specification Brochure & specs Operating instructions

Contents

Panasonic AG-DVX100A Operating Manual Manual pdf 67 page image

67 (E)ENGLISHTroubleshooting (Q&A)Other types of problemsQ1: The cassette tape cannot be ejected.A1: Is power being supplied?Has the AC adapter been plugged in orthe battery inserted properly?When the power is supplied, the cassettecan be ejected without setting thePOWER switch to ON.Q2: Ejecting the cassette tape is the onlyoperation which can be performed.A2-1: Has any condensation formed?If condensation forms, ejecting thecassette tape is the only operation whichcan be performed. Wait until thecondensation dries up. (See page 64)A2-2: When the cassette holder is closedimmediately after opening (by sliding theEJECT switch), operations other thaneject may not be possible.If this does happen, slide the EJECTswitch to open the cassette holder onceagain, then close the holder after ensuringthat the cassette mechanism hascompleted the eject operation.Q3: The remote control unit does not work.A3-1: Has the battery in the remote control unitrun down?If the remote control unit fails to operateeven when it is operated near the remotecontrol sensor of the camera recorder, itmeans that the button battery has rundown.Replace it with a new one. (See page 19)A3-2: Do the remote control settings matchproperly?If the [REMOTE] settings of the remotecontrol unit and camera recorder do notmatch, the remote control unit will notwork even when it is operated. (See page19)Q4: A rattling sound is heard when thecamera recorder is tilted toward thefront or back.A4: When the VCR mode is established or thepower switch is at OFF, a rattling soundmay be heard from the camera unit due toits structure. This is not indicative ofmalfunctioning.Playback-related problems(audio)Q1: No playback sound is heard from thecamera recorder’s speaker.A1: Has the camera recorder’s volume levelbeen set too low?In the VCR mode, press the AUDIOMON/VAR button “+” to increase thevolume. (See page 14)Q2: More than one recorded stream ofsound is heard.A2: Has MIX been selected as the setting forthe 32K (12-bit) AUDIO item on thesetting menu PLAYBACK FUNCTIONSscreen? (See page 44)If audio dubbing editing is performed on atape recorded with 32K (12-bit) selectedas the setting for the AUDIO REC item onthe setting menu RECORDING SETUPscreen, the sound heard during therecording and the sound recorded laterwill be heard together. It is also possibleto listen to each stream of soundseparately. (See page 44Q3: When audio dubbing is performed, theoriginal sound is erased.A3: When audio dubbing is performed for apart which was shot with 48K (16-bit)selected as the setting for the AUDIOREC item on the setting menuRECORDING SETUP screen, the originalsound will be erased. Use the 32K (12-bit) setting during shooting. (See page44)