Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual

Also see for AGHPG10 - MEMORY CARD PORTABLE RECORDER: Operating instructions Brochure & specs

Contents

Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual Manual pdf 56 page image

56Thumbnail displays of clips on the hard driveYou can also display and manage thumbnails of the clips stored on the hard drive just as you can with clipson the P2 cards installed in the unit.1 Display the Explorer screen.2 Using [STOP] and [PLAY], select thepartition to be displayed, and press [STILL].The clips of the partition are now displayed asthumbnails.3)1)2) 4)1) Display statusesDisplay the thumbnail display status of the harddrive clips.2) Partition informationThe following information is displayed.SERIAL: Serial number of P2 cardMODEL: Model name of P2 cardNUMBER (NO.): Partition number (starting from 1)DATE/ TIME: Partition recording date/timeVERIFY: Setting for verifying duringrecording, and verifying resultsON :FINISHEDThe two sets of datahave been verifiedand found to match.ON :FAILEDThe two sets of datahave been verifiedand found not tomatch.OFF The two sets of datawere not verified.∗ “– –” is displayed in the case ofa P2 store hard drive.3) Recording mode and system formatThe recording mode of the clip at the cursorposition and system format are displayed.4) Disk informationFor details, refer to the previous page.• When the menu is displayed and “EXIT” isselected, the Explorer screen is restored.• If necessary, you can change the displays on thethumbnail screen. The steps taken to do this arethe same as for the thumbnail displays for cards.Refer to “Changing the displays on the thumbnaildisplay screen.”• Even with a FAT type of hard drive, clips after thefirst thousand clips will not be displayed.• Using [PAGE/AUDIO MON/VAR], you canmove operation to the thumbnail displays of theprevious or next partition.Displaying the clip informationYou can display the meta-data of the clips storedon the hard drive. This information is the same asthe properties of the clips on the P2 cards.1 Select the target clip on the thumbnailscreen of the hard drive.You can display detailed information about clipson the screen, and check it.2 Press [MENU].3 Using [STOP], [PLAY] and [STILL], select“PROPERTY” – “CLIP PROPERTY”, andpress [STILL].For details, refer to “Displaying the clipinformation.”Copying data from P2 cards to the hard drive (USB HOST mode) (continued)