Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual

Also see for AGHPG10 - MEMORY CARD PORTABLE RECORDER: Operating instructions Brochure & specs

Contents

Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual Manual pdf 64 page image

64Screen displays (continued)16 Remaining media memory displaysThe amount of memory remaining on thecard in the slot targeted for recording isdisplayed when “ONE CARD” is selectedas the “P2 CARD REMAIN” item setting onthe setting menu “DISPLAY SETUP” screen.The target slot can be switched to anotherslot using “SLOT SEL” assigned to [USER].When “TOTAL” is selected, the total amountof memory remaining on the two cards isdisplayed.17 Media information displaysThe card slots in which P2 cards have beeninserted and the basic information on the slotsare displayed.1 2 Lighted:Recordable P2 card1 2 Lighted in green:P2 card targeted for recording1 2 Blinking:Card recognition underway:No card insertedP : Write-protected cardF : No more free memoryX : Card cannot be recognizedE : Improperly formatted P2 card (which can beused if it is formatted properly)18 Monitor volume level meterWhen [PAGE/AUDIO MON/VAR] is pressed,the level of the volume which is output fromthe internal speaker and headphone jack isdisplayed. You can adjust the volume levelusing the [+] and [–] buttons.Warning displaysLOW BATTERYNo operation is possible because the batterycharge is depleted.INCOMPATIBLE CARDThe card complies with the different standard andso it cannot be used.COPY INHIBITEDThe input signals are copy-guarded so theycannot be recorded correctly.DIR ENTRY NG CARDThe card contains folders which are organizedillegally. It cannot be used for special types ofrecording (interval recording, one-shot recordingor loop-rec). A warning will be displayed whenthis P2 card is inserted into a P2 device or whenrecording has ended.RUN DOWN CARDThe P2 card has reached the end of its servicelife. It is recommended that you replace it. Evenwhen a warning appears, it can still be used forrecording or playback. However, a warning willbe displayed when this P2 card is inserted into aP2 device or when recording has ended.FORMAT ERR !The card does not comply with the P2 standard.< Thumbnail screen>CANNOT ACCESS!Data cannot be accessed because of a problemin the content or for some other reason. Restorethe media or clips to the normal operating status,and then use the data.WRITE PROTECTED!The P2 or SD card is write-protected. Insert amedia on which data can be saved.NO CARD!The P2 or SD card has not been inserted. Inserta media which is supported.CARD FULL!There is no more free memory on the P2 or SDcard. Insert a media with free memory.CANNOT DELETE !Data cannot be deleted because of a mismatchin the content versions. Ensure that the samecontent version as the device is used.CANNOT FORMAT!The P2 card cannot be formatted because of aproblem. Check the P2 card.CANNOT REPAIR!The content cannot be repaired because thereis nothing wrong with it or because of a similarreason. Check the selected content.CANNOT RE-CONNECT!Clips cannot be reconnected because contentwhich is contained on no more than one card hasbeen selected or because of a similar reason.Check the selected content.NO COPY TO SAME CARD!Data cannot be copied because the same cardis being used for the copy source and copydestination. Copy the data onto a card whichdoes not contain the selected clip.TOO MANY CLIPS!Too many clips have been selected. Reduce thenumber of clips which have been selected.