24Setup (Initial Settings)SET–UP MENU NOFACTORY (ALL)FACTORY (NOT SYSTEM)USER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to move the cursor to FACTORY (ALL),and press the SET button.O If the cursor is moved to FACTORY (NOTSYSTEM) and this operation is performed, allthe menus except the SYSTEM menu will berestored to the factory settings.O If the cursor is moved to NO and this operationis performed, operation will return to the menuscreen without restoring the factory settings.4Press the MENU-UP button or MENU-DOWNbutton to move the cursor to USER (ALL), andpress the SET button.O If the cursor is moved to USER (NOTSYSTEM) and this operation is performed, allthe menus except the SYSTEM menu will beupdated.O If the cursor is moved to NO and this operationis performed, operation will return to the menuscreen without updating the settings.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.The menu setting procedure is now terminated.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.The menu setting procedure is now terminated.7SET–UP MENU NOUSER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to position the cursor at SAVE, andpress the SET button.The unit is set to the SAVE mode, and the SAVEscreen appears on the video monitor.4SAVE OK?NOYESThe screen to confirm whether SAVE is to beinitiated or canceled now appears. Press theMENU-UP button or MENU-DOWN button tomove the cursor to the YES position, andpress the SET button.The settings are now saved in the memory.6How to set the user defaultsettingsSet the LOCAL/MENU/REMOTE switch to theMENU position.The unit is now set to the menu setting mode,and the menu screen appears on the videomonitor.1Performs steps 2 through 6 of “How toperform the settings using the on-screenmenus,” and change to the desired settings.(See page 23)2Press the RESET button.The unit is set to the default setting mode, andthe default setting screen appears on the videomonitor.3SELECT MODEESCAPELOADSAVEPROTECTPress the MENU-UP button or MENU-DOWNbutton to position the cursor at LOAD, andpress the SET button.The unit is set to the LOAD mode, and the LOADscreen appears on the video monitor.3