Panasonic AJ-PCD30PJ Operating Instructions Manual

Also see for AJ-PCD30PJ: Brochure

Contents

Panasonic AJ-PCD30PJ Operating Instructions Manual Manual pdf 18 page image

18Overview of dedicated software (continue)5 Check that “Connection Status: Connected(DC 16 V)” is displayed at the bottom left ofthe Power Management Setting Softwarewindow.The device can be set to switch offautomatically. (page 10)6 Shut down the Power Management SettingSoftware.For Windows:Click × button at the top right of the window.For Macintosh:Click × button at the top left of the window.Power Management SettingSoftware windowTime after which device automaticallyswitches offYou can set time after which the power isautomatically switched off in an externaldevice (power is supplied by the AC adaptor)when the P2 card is not accessed to read orwrite. Select from among Off/1 hour/2 hours/4 hours/8 hours.The default setting at shipping is “4 hours”.When the device is connected to your PCexternally, “Connection Status: Connected(DC 16 V)” is displayed at the bottom left ofthe window and the settings can be altered.When not connected, “Connection Status:Disconnected” is displayed and the settingscannot be altered.The current settings of the device aredisplayed in the “Current Settings” column.To alter the settings, select the new settingsand then click the “Set” button. The newsettings will be enabled when you restart thedevice. After altering the settings, switch thedevice off and then on again.z If you start up the Power ManagementSetting Software while using the deviceinternally, “Unable to perform settingchanges due to power from DC IN 12 V.”will be displayed and you cannot alter thesettings. The automatic switch-off functionis disabled.z The Power Management Setting Softwaredoes not support connection of 2 of thedevices. Perform the settings separatelyfor each device.