Panasonic AJ-RC10G Operation Manual

Also see for AJRC10G - REMOTE CONTROL UNIT: Operating instructions

Panasonic AJ-RC10G Operation Manual Manual pdf 15 page image

E-14ENGLISHBasic operationsWhen the power is onWhen the POWER button is pressed, the lampfor the PANEL ACTIVE button is on, and thesettings of the camera recorder are read into theunit.The respective numerical values are displayedon the PRE/A/B display, ND display, GAINdisplay, and the IRIS display, while R GAIN and BGAIN are displayed on the LCD panel.In this case, only the PANEL ACTIVE button, theSW ACTIVE button, the VR ACTIVE button, theAUTO IRIS button, M.PED volume and the IRISvolume can be operated from the unit, whileother buttons and volumes are not operative.However, the settings on the A.KNEE ON button,the SHT ON button, the AUTO IRIS button, theBAR ON/OFF button, the CHARA ON button andthe shutter setting values will be in the states thathad been set on the unit at the last time.To enable the buttons/volumesWhen the SW ACTIVE button is pressed and thelamp is on, button operations are enabled.1) Operations of the camera partWhen the SW ACTIVE button is pressed,operations of the USER MAIN button, GAINand the camera recorder such as storingscene files in the built-in memory or readingthem out, are enabled.When the SW ACTIVE button is pressedagain, the lamp is tuned off and buttonoperations are inhibited, while the state ofsettings that have already been set previouslyis remained as it is.2) Operation of the recording partWhen the lamp of the RECORDER ENABLEbutton is turned off, operations of therecording part are disabled. Turn on the lampof the RECORDER ENABLE button bypressing the button, and then operate thebuttons of “PLAY”, “FF” or “REW”.To record signals, operate the REC S/Sbutton.3) To display numerical values on theLCD panelThe GAIN volume is displayed when thepower is on.If the button operations are enabled, it ispossible to switch the displayed GAIN volume# BLACK volume # a numerical value for M/PED # TC step-by-step by using the 3buttonand the 4button.When volume operation is enabled, thevolume level is forcibly displayed if the GAINvolume or the BLACK volume is operated.However, it is possible to return the screen tothe state before operating the GAIN volumeor the BLACK volume by pressing the RotaryEncoder 3.It is impossible to switch the display when theunit menu or the camera menu is operating.The volume level is not displayed even if thevolume is operated.To disable buttons/volumesIf the lamp of the PANEL ACTIVE button isturned off, operations using the buttons and thevolume on the panel are inhibited.If the lamp of the VR ACTIVE button is turned offby pressing the button, setting the GAIN andBLACK using the volume controls is inhibited.Use this feature if you intend to retain thesettings. However, note that if the volume ismoved when inhibited, the volume level changewill be reflected immediately after turning on thelamp of the PANEL ACTIVE button and/or the VRACTICE button by pressing the button again.It is possible for the GAIN and the BLACK toavoid changes in the volume position during theinhibition by setting the volume mode on the unitmenu to a relative value (REL).