E-19Saving/Loading of scene files onto the SD memory cardIt is possible to store up to 8 sets of settings forthe unit.While data on the card are read or written, anyoperation of the unit panel is inhibited. Insert theSD memory card into the SD memory card sloton the unit and operate the unit menu.z Use an SD memory card with a capacity of 8MB or more. The maximum capacity of an SDcard that can be used on the unit is 2 GB.z The SD memory card must be formatted onthe unit.Handling methods for the SDmemory cardEnsure that the SD memory card is inserted orejected in the proper direction.When the SD memory card is used for the firsttime, execute CARD CONFIG in SYSTEM on theunit menu.While data are being stored on the SD memorycard or data are being loaded from the SDmemory card, do not remove the SD memorycard. Otherwise, data on the SD memory cardmay be damaged.To load data from the card1 When “SYSTEM” is selected using theSHUTTER/SYSTEM button, the indication“CARD-RD” is displayed on the LCD paneltogether with the value displayed under theindication and the title next to the indication.2 Select the file to read out by changing thenumerical value in the Rotary Encoder 1.If there is no applicable file, the indication“NO FILE” is displayed on the LCD panel.3 Press the Rotary Encoder 3.When the indication “READ NO?” isdisplayed on the LCD panel, turn the RotaryEncoder 3 to select “YES?” and press theRotary Encoder 3 again to start reading outthe data.4 The read operation starts and the indication“ACTIVE” is displayed on the LCD panel.While the data are loaded, the SD memorycard access lamp is on.5 When the reading the data is finished, theSD memory card access lamp turns off andthe indication “OK” is displayed on the LCDpanel.If the data cannot be read properly, theindication “READ NG” is displayed on theLCD panel. Execute the load operationagain. If the load operation is not executedproperly, replace the SD memory card with anew one.SD memory cardslotSD memory cardaccess lamp
