Panasonic AK-HC3500P Operating Instructions Manual

Also see for AK-HC3500P: Operating instructions

9 RET-A selector switch [RET A]This switch is used to select the return images to beswitched by RET-A.The return images which have been set on the ROPmenu are allocated to this switch. RET-B selector switch [RET B]This switch is used to select the return images to beswitched by RET-B.The return images which have been set on the ROPmenu are allocated to this switch. CALL LEDThis lights up green when the CALL switch is pressedfrom the ROP, MSU or CCU. CALL switch [CALL]This lights the CALL LED on the ROP or MSU andsounds the buzzer (when ON has been selected as thebuzzer setting). OPT LEDThis indicates the camera’s optical signal receptionstatus. It normally lights up green. When any problem hasoccurred, it lights up red.When a problem has occurred, clean the optical fiberconnector.If the problem is not cleared up, immediately turn off thepower, and contact your dealer. Back tally LED selector switchThis is used to set the back tally LED to ON or OFF. Back tally LEDThis lights when the tally signal is supplied.This lights up red when the R tally signal is supplied,green when the G tally signal is supplied, and red whenboth the R and G tally signals are supplied. RET switching control connector [RET CONT]The cable of the RET switching box (optional accessory)is connected here for controlling the ON/OFF of RET1, 2,3 and INCOM1, 2 MIC. External I/O [EXT I/O]This signal interface connector is designed to supportfuture interfacing with external devices. Camera HD-SDI output1 connector (BNC)[HD-SDI1]The camera HD-SDI images are output from thisconnector. Camera HD-SDI output2 connector (BNC)[HD-SDI2]Camera images, VF images or RET images can beselected on the camera menu to output HD-SDI signalsfrom this connector. Optional video connector (BNC) [AUX]This is an auxiliary input/output connector.The HD analog Y input or Prompt2 output (when the CCUhas a Prompt2 input) can be selected.When a down-converter (optional accessory) has beeninstalled in the camera, this connector can be used as aVBS or D1 output connector. Genlock sync input/PROMPT output connector[PROMPT/GL]When the GL/PROMPT selector switch is set to GL,the reference signal (tri-level SYNC or B.B.) which isused to genlock the camera is input to this connector;Genlock sync signals are input to this connector whenthe CCU is not connected. When it is set to Prompt, thePrompt images input from the CCU are output from thisconnector. GL/PROMPT selector switchThis is used to select the genlock input or the input/output(genlock input and PROMPT output) signals of thePROMPT output connector. Remote connector [REMOTE]The remote operation panel (ROP, optional accessory) isconnected to this connector.The [SYSTEM], [FUNC] and [SD DTL] menus of the ROPcannot be controlled.Neither can the [HEAD POWER], [CHARA], [BAR],[MONO], [SD DTL OFF] and [MONITOR (R/G/B/SEQ/ENC)] switches be controlled. External power supply input connector [DC IN]The input of the external DC power supply is connectedto this connector. (DC 10.8 V to 17 V) MIC1 selector switch [LINE/FRONT MIC/MIC]This is used to switch the input signal to LINE, FRONTMIC or rear MIC.Controls and their functions