86. External interfacesThis unit comes with RS-4, GPI and tally connectors to serve as external interfaces.6-1. RS-422 connectorThis enables the unit to be controlled by an external device.Use it with the settings below. (D-sub 9-pin, female)Baud rate:38400 bpsParity:ODDStop bit:1 bit123459876Pin assignmentPin No.Signal nameDescription of signal1FRAME GROUNDFrame groundTXD –Send data (–)3RXD +Receive data (+)4GROUNDGround5NCNot used6GROUNDGround7TXD +Send data (+)8RXD –Receive data (–)9FRAME GROUNDFrame groundThe following lists the functions which can be controlled by editing controller AG-A850.(Compliant with the GVG protocol)• Crosspoint switch• Wipe pattern selection (BKGD)• Transition mode (MIX/WIPE) selection• Auto transition time setting• Auto transition execution
RS-422 controlAV-HS400RS-422 controlAV-HS400RS-422 controlAV-HS400RS-422 controlAV-HS4000WIPE #11SQ #14SL #1363D #11WIPE #13SQ #5SL #373D #WIPE #314SQ #36SL #3383D #33WIPE #415SQ #47SL #4393D #44WIPE #516SQ #58—403D #55WIPE #617SQ #69SL #6413D #66WIPE #718SQ #730SL #743D #77WIPE #819SQ #831SL #8433D #88WIPE #90SQ #93SL #9443D #99WIPE #101SQ #1033—453D #1010WIPE #11—34—463D #1111WIPE #13SQ #135—473D #1: Set “No.56” when control is to be exercised from the AG-A850.On the System sub menu of the SYSTEM menu, set On or Off for control from the external device (editor)connected to the RS-4connector.For details on the settings, see 5-6-.