Pan/Tilt Head Controller AW-RP40023 (E)Parts and their functionM EXT CONT IN/OUT connectorsWhen an additional AW-RP400 controller is to beprovided, connect these connectors on the twoAW-RP400 controllers using a 10BASE-T (equivalent toUTP category 5) straight cable.N CAMERA CONTROL IN FROM RCB [P1] to [P5]connectorsConnect the WV-CB700A remote control boxes to theseconnectors.The cameras installed on the pan/tilt headscorresponding to the ports where the WV-CB700A boxeshave been connected can then be controlled.When even one WV-CB700A box is connected, thecameras cannot be controlled from the AW-CB400remote operation panel even if the AW-CB400 isconnected.O TALLY/INCOM connectorConnect this to the TALLY/INCOM connector on thevideo switcher or other unit.When the TALLY input connector is set to the GND level,the TALLY lamp on the controller or pan/tilt head lights.Do not apply a voltage in excess of 5V to this connector.Use the accessory plug (D-SUB 15-pin) to connect thetally/INCOM signals to the system.Connect a 4-wire INCOM system to the INCOMconnector.When an additional controller has been provided or whenthe AW-CB400 remote operation panel has beenconnected, the tally or INCOM function of all the units willtake effect if tally or INCOM signals are connected to oneof the units.M N O P QUTSR$ Rear panelPin No. Signal name1 TALLY19 TALLY22 TALLY310 TALLY43 TALLY511 TALLY GND4 – – –12 – – –5 – – –13 – – –6 MIC+14 MIC–7 INCOM GND15 SP–8 SP+87654321?>=<;:9Pin layout as seen from theback panel of AW-RP400MastercontrollerAW-RP400EXT CONTINEXT CONTOUTEXT CONTINEXT CONTOUT10BASE-T10BASE-T straight cableSlavecontrollerAW-RP400