Indoor Pan/Tilt Head AW-PH40018Installation (Be sure to ask your dealer to install the unit.)$ Attaching the wireThe wire is not provided. Use one which is strong enough to bear the weight of the whole camera (camera + lens).When mounting the cameras with fan (AW-E655, AW-E750, AW-E800, AW-E800A)1 Use the wire mounting screw (M4!8 mm with flat washer and spring washer) to attach one end of the wire to the pan/tilthead’s arm.2 Mount the mounting spacer on the top panel of the camera.3 Use the wire mounting screw (M4!6 mm with flat washer and spring washer) to attach the other end of the wire to the screwhole of the mounting spacer.When mounting the cameras without fan (AW-E350, AW-E650, AW-E300, AW-E300A, AW-E600)1 Use the wire mounting screw (M4!8 mm with flat washer and spring washer) to attach one end of the wire to the pan/tilthead’s arm.2 Use the wire mounting screw (M4!6 mm with flat washer and spring washer) to attach the other end of the wire to the screwhole of the top panel of the camera.❈ Be absolutely sure to tighten up the mounting spacer and screws securely using a tool such as a screwdriver.For a stand-alone installation For installation on the ceiling≥ Camera: AW-E750 ≥ Camera: AW-E750≥ Camera: AW-E650, AW-E350 ≥ Camera: AW-E650, AW-E350M4!6 mm wiremounting screwwith flat washerand spring washer M4!6 mm wire mountingscrew with flat washer andspring washerM4!8 mm wiremounting screwwith flat washerand spring washerM4!8 mm wire mountingscrew with flat washer andspring washerMountingspacer(supplied withAW-E750) Mounting spacer(supplied withAW-E750)WireArm