Panasonic AW-RC400N Operating Instructions Manual

Panasonic AW-RC400N Operating Instructions Manual Manual pdf 23 page image

Pan/Tilt Control Panel AW-RP400AW-RP40023Parts and their function1 EXT CONT [M/S] switchThis switch is normally kept at the [M] (master) position.When an additional AW-RP400 control panel has beeninstalled, set the EXT CONT switch on the additional unitto [S] (slave).If no additional AW-RP400 control panel is going to beinstalled, the EXT CONT switch on this control panelmust be kept at the [M] (master) position without fail.2 OPERATE lampThis lights up green when the (3) OPERATE switch is atON. It goes off when the switch is set to OFF.3 OPERATE [OFF/ON] switchWhen this switch is set to [ON], the power supply fromthe connected pan/tilt heads to the cameras is turned on,and system control is enabled.When it is set to [OFF], the power supply from theconnected pan/tilt heads to the cameras is turned off.4 INCOM jackThe INCOM (inter-communication) headset is connectedhere.5 LEVEL controlUse this to adjust the volume of the headset’s receiver.6 CALL buttonWhen this button is pressed, the buzzer of the connectedcontrol panel sounds, and the CALL button lamp lights.1IHGEDCBA@?>=<; FJKL23456789:$ Front panelNOTE≥ The centering of the joystick and zoom switch isadjusted when the OPERATE switch has been set to[ON]. Therefore, do not touch the joystick or zoomswitch while this switch is at the [ON] position.≥ When an additional AW-RP400 control panel isinstalled and used, it will not be possible to exercisecontrol from the slave control panel unless theOPERATE switches not only on the slave control panelbut on the master control panel as well are set to [ON].Remember to set the OPERATE switch on the slavecontrol panel to [ON] first before setting the OPERATEswitch on the master control panel to [ON].