Panasonic AlCare TK-AS500 Operating Instructions Manual

Indications and SolutionsIndication Cause and solutionElectrolysis is stopped to protect the product.(Purified water is coming out from the main spout.)This may occur depending on the quality of tap water, environment, and usage.→ Stop water, wait approx. 3 minutes, and run water again.Electrolysis is stopped to protect the product.(Purified water is coming out from the main spout.)This may occur depending on the quality of tap water, environment, and usage.→ Stop water, and wait approx. 30 minutes until the display disappears.(Depending on the quality of tap water, environment, and usage, it may take 30 minutes ormore for the display to disappear.)The flow rate has been 1.2 L or less per minute for longperiods.→ Disconnect the power plug once, and connect it again.Make sure that there is no flow rate shortage due to low water pressure, or hose breakage/crush.Clean the filter if it is clogged. (P. EN28)After checking the above, if is still displayed, clogging of the cartridge has causedthis problem.Replace the cartridge since the cartridge has reached the replacement timing. (P. EN30)(Depending on the quality of tap water, the cartridge may get clogged earlier. (P. EN29))The cartridge has reached the replacement timing accordingto the total flow amount.Total flow amount has exceeded 12 000 L, a guideline for replacement.→ Replace the cartridge. (P. EN30) When the indications do not disappear even if the above measures are takenDisconnect the power plug, and contact the dealer.Error indication starting with “H”z Do not disassemble the product for repair by yourself.Indication Cause and solution– A product failure has occurred.→ Disconnect the power plug, and contact the dealer.The electrolyzer has reached the time limit of usage.(The cumulative electrolysis time including cleaning time has reachedapprox. 850 hours.)→ Request the dealer to replace the electrolyzer.EN35When necessaryEnglish