Panasonic BB-HNP17A Operating Instructions Manual

Also see for BB-HNP17A: Product catalog Hardware

Contents

Panasonic BB-HNP17A Operating Instructions Manual Manual pdf 161 page image

4.1.3 Motion DetectionMotion Detection SettingsMotion detection can only be set on cameras connected to the network camera recorder software on the samenetwork (LAN).Motion detection can also be set for cameras set to [MPEG-4] or [H.264] data formats in the Image Settings.Cameras connected over the Internet cannot perform motion detection.• Motion detection can be selected to either [Perform motion detection with this software] or [Perform motiondetection with the camera].Perform motion detection with this software Motion detection is performed with this software.Perform motion detection with the camera Motion detection is performed with the camera.• When [Perform motion detection with the camera] is selected, motion detection can also be set for camerasset to [MPEG-4] or [H.264] data formats.Motion detection will not function until the motion detection area is configured.When the [Auto settings of the camera] (Basic Settings in the Preferences) of this program is enabled andonly when motion detection is not configured on the camera, the camera will automatically be set to detectall areas of motion detection area 1. These settings will not be enabled when motion detection is alreadyconfigured.The camera will be set to [Non-preset positions] in case the preset position is not configured.If the preset position has already been configured, [Non preset positions] will be set to the 10 most recentposition numbers.Please configure the motion detection settings directly on the camera, when [Auto settings of the camera]is disabled.• When [Perform motion detection with the camera] is selected, the motion detection status bar is notdisplayed.• When [Perform motion detection with the camera] is selected, 10 seconds or more are needed beforerecording can start after detection.Note• When [Perform motion detection with the camera] is selected, the motion detection monitoring screenis not displayed.• When [Perform motion detection with the camera] is selected, the camera's Panasonic alarm protocolnotification will be used. For more information about the Panasonic alarm protocol notification function,see your network camera user manual.Operating Instructions 1614.1.3 Motion Detection