Installation/Troubleshooting5[For assistance, please call: 1-800-272-7033]1.1.1 FCC and Other InformationThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Some wireless Cameras operate at frequencies that may cause interference tonearby TVs and VCRs. To minimize or prevent such interference, the base of thewireless Camera should not be placed near or on top of a TV or VCR. Ifinterference is experienced, move the wireless Camera further away from the TVor VCR. This will often reduce or eliminate interference. Operating near 2.4 GHzelectrical appliances may cause interference. Move away from the electricalappliances.Environment:Do not install the camera where the temperature is less than 5 °C (+41 °F) orgreater than +40 °C (+104 °F). Allow 10 cm (4 inches) clearance around the unitfor proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock,or direct sunlight.Routine care:Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder.When you leave the unit unused for a long period of time, unplug the AC adaptorfrom the outlet.If you have any problems:Consult an authorized Panasonic Factory Service Center.