Panasonic BT-LH1760W Operating Instructions Manual

Also see for BT-LH1500p: Operating instructions Operating instructions

20Underlined values indicate factory defaults.*1 In split-screen display, changes are not reflected to the still image in the main window.*2 These functions are not available when “RGB-COMP.” under “YPBPR /RGB” or “DVI-COMP.” under “DVI-D” isselected in the “INPUT SELECT” menu (J page 30).*3 The following sharpness values are available and the settings for the selected input signal is displayed.Adjustment status during selection appears at the bottom right of the screen.1) VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0)2) HD for any other input (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/V: 0).3) SD for any other input (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0).*4 Selecting “VAR1”, “VAR2” and “VAR3” engages the WB adjustment mode (J page 21).*5 To select USER0 - 63,1) Press [ENTER] (“USER” changes to blue). 2) Use [ , ] to select 0 - 63 and press [ENTER].*6 To use the “SUB WINDOW” (J page 25) function,1) Change settings after exiting the “SUB WINDOW” function.2) It is recommended to use “MODE2” for handling fast video.*7 “SCAN” changes are not reflected in Anamo size display.VIDEO CONFIGSub menu Settings DescriptionGAMMASELECT*1*2 STANDARDFILMSTDIO/PSTSelects gamma curve. Standard mode Film mode Color emphasis mode (a mode that approximates CRTdisplay capability suitable for studio or postproductionapplication)The mark appears at the top left of the screen when “FILM”is selected.FILM GAMMA*2 VARICAMOTHERSelects type of FILM gamma mode. For VARICAM use OtherCOLOR TEMP. USER0 - 63*5D93D65D56VAR1VAR2VAR3Selects color temperature. Adjustable settings 0 - 63 (equivalent to a colortemperature range of 3,000 - 9,300K) Equivalent to a color temperature of 9,300K Equivalent to a color temperature of 6,500K Equivalent to a color temperature of 5,600K WB adjustment mode*4 WB adjustment mode*4 WB adjustment mode*4SHARPNESSMODE*2 HIGH*3LOWSelects the width of outline correction edge. Thin edge Wide edgeSHARPNESS H*2 0 - 30 *3 Sets horizontal outline correction. The item display moves to the lowerpart of the screen during adjustment.SHARPNESS V*2 0 - 30 *3 Sets vertical outline correction. The item display moves to the lower part ofthe screen during adjustment.I-P MODE*2*6 MODE2MODE1Selects IP conversion mode. (J page 21, “IP mode”) Inter-field interpolation Inter-frame interpolationMONO*2 OFFONSwitches between color and monochrome (MONO). Color Monochrome* When ON, the CHROMA setting of the picture adjusting knob is fixed at 0.ANAMO*2*7 OFFONWith an Anamo lens and SDI 720/60P, 59.94P input, the picture isresized to Anamo magnification (the vertically enlarged signal can bevertically compressed and corrected for display).SD ASPECT*2 4:316:9Sets the aspect ratio for SD signal input.<4:3> 4:3 display <16:9> 16:9 displaySCAN*2 NORMALUNDERSets under-scan and normal display. Normal display Under-scanMain Menu (continued)