Panasonic BT-LH2550 Operating Instructions Manual

Also see for BT-LH2550: Brochure Specifications Brochure & specs Menu information

3Read this first ! (for BT-LH2550P) (continued)FCC NOTICE (USA)IMPORTANT SAFETY INSTRUCTIONS1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use this apparatus near water.6) Clean only with dry cloth.7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (includ-ing amplifiers) that produce heat.9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two bladeswith one wider than the other. A grounding-type plug has two blades and a third grounding prong. Thewide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet,consult an electrician for replacement of the obsolete outlet.10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,and the point where they exit from the apparatus.11) Only use attachments/accessories specified by the manufacturer.12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or soldwith the apparatus. When a cart is used, use caution when moving the cart/apparatus combi-nation to avoid injury from tip-over.13) Unplug this apparatus during lightning storms or when unused for long periods of time.14) Refer all servicing to qualified service personnel. Servicing is required when the apparatushas been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled orobjects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not oper-ate normally, or has been dropped.Declaration of ConformityModel Number: BT-LH2550PTrade Name: PanasonicResponsible Party: Panasonic Corporation of North AmericaOne Panasonic Way, Secaucus, NJ07094Support contact: Panasonic Broadcast & Television Systems Company1-800-524-1448This device complies with Part 15 of FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.To assure continued compliance, follow the attached installation instructions and do not make any unautho-rized modifications.Note:This equipment has been tested and found to comply with the limits for a class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-ference in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy, and if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particular instal-lation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference byone of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.The user may find the booklet “Something About Interference” available from FCC local regional offices helpful.Warning:To assure continued FCC emission limit compliance, follow the attached installation instructions and the usermust use only shielded interface cables when connecting to host computer or peripheral devices. If DVI-D portis to be used it must connected to PC by compatible interface cable with two ferrite cores. Also, anyunauthorized changes or modifications to this equipment could void the user’s authority to operate this device.S3125A