6Read this first !EMC NOTICE FOR THE PURCHASER/USER OF THE APPARATUS1. Applicable standards and operating environment (BT-LH2550E)The apparatus is compliant with:• standards EN55103-1 and EN550103-2 1996.and• electromagnetic environments E1, E2, E3 and E42. Pre-requisite conditions to achieving compliance with the above standards<1> Peripheral equipment to be connected to the apparatus and special connecting cables• The purchaser/user is urged to use only equipment which has been recommended by us asperipheral equipment to be connected to the apparatus.• The purchaser/user is urged to use only the connecting cables described below.<2> For the connecting cables, use shielded cables which suit the intended purpose of theapparatus.• Video signal connecting cablesUse double shielded coaxial cables, which are designed for 75-ohm type high-frequency applications,for SDI (Serial Digital Interface).Coaxial cables, which are designed for 75-ohm type high-frequency applications, are recommendedfor analog video signals.• Audio signal connecting cablesIf your apparatus supports AES/EBU serial digital audio signals, use cables designed for AES/EBU.Use shielded cables, which provide quality performance for high-frequency transmission applications,for analog audio signals.• Other connecting cables (IEEE1394, USB)Use shielded cables, which provide quality performance for high-frequency applications, asconnecting cables.• When connecting to the DVI signal terminal, use a cable with a ferrite core.• If your apparatus is supplied with ferrite core(s), they must be attached on cable(s) followinginstructions in this manual.3. Performance levelThe performance level of the apparatus is equivalent to or better than the performance level required bythese standards.However, the apparatus may be adversely affected by interference if it is being used in an EMC environment,such as an area where strong electromagnetic fields are generated (by the presence of signal transmissiontowers, cellular phones, etc.). In order to minimize the adverse effects of the interference on the apparatus incases like this, it is recommended that the following steps be taken with the apparatus being affected andwith its operating environment:1. Place the apparatus at a distance from the source of the interference.2. Change the direction of the apparatus.3. Change the connection method used for the apparatus.4. Connect the apparatus to another power outlet where the power is not shared by any otherappliances.