9[SYSTEM CONFIG]BACKLIGHT 60STATUS DISPLAY CONTINUE[INPUT SELECT]LINE B ONCMPNT ONSDI ONREMOTE OFFBACKLIGHTThe backlight brightness is adjusted to a value from 0 to 60here. 60 is the factory setting.STATUS DISPLAYThe information displays during input switching and inputsignal system display are set here.≥ CONTINUEThe information remains displayed. This is the factorysetting.≥ 3 SEC OFFThe information is displayed for 3 seconds, after whichit is cleared from the display.≥ OFFNo information is displayed.INPUT SELECTLINE BBy setting this item to OFF, LINE B can be skipped.CMPNTBy setting this item to OFF, CMPNT can be skipped.SDIBy setting this item to OFF, SDI can be skipped. Thisitem is valid only when the optional SDI input unit (BT-YA210G) is installed.REMOTEExternal control is set to ON or OFF here.¥ SYSTEM CONFIG menuThe menu items shown below appear when the SYSTEM CONFIG menu is selected on the main menu.How to use the on-screen menusASPECTAn aspect ratio of 4:3 or 16:9 can be set.The underscanning function cannot be used when 16:9 hasbeen selected.COMPONENT LEVELThe component input level is selected here. This menu itemappears only when the component signal has been selectedas the input signal.≥ SMPTESelect this when signals from a DVD or M II VTR aresupplied.≥ B75Select this when signals with a 7.5% setup level aresupplied from a Betacam VTR.[VIDEO CONFIG]ASPECT 16:9COMPONENT LEVEL SMPTE¥ VIDEO CONFIG menuThe menu items shown below appear when the VIDEO CONFIG menu is selected on the main menu.