Panasonic BTLH2550E - LCD VIDEO MONITOR Operating Instructions Manual

Also see for BTLH2550E - LCD VIDEO MONITOR: Operating instructions

12SDI (HD/SD) terminal (BNC)IN1 : This is the SDI input terminal (compatible with HD/SD automatic switching).IN2 : This is the SDI input terminal (compatible with HD/SD automatic switching).SWITCHED OUT : This is the active through-out terminal for the SDI input signal being displayed on thescreen.• Active SDI through-out is only output when [SDI1] or [SDI2] is selected using the [INPUT] button. It is notoutput when something other than SDI is selected. This terminal supports embedded audio.DVI-D terminal (DVI-D)An HDCP compliant DVI-D signal input terminal.VIDEO terminal (BNC)*1IN : This is the VIDEO signal (composite signal) input terminal.OUT : This is the input signal through-out terminal.AUDIO IN terminalThis is the common audio input terminal for all video input terminals.• SDI input audio is automatically selected by selecting [SDI1] or [SDI2] with [INPUT SELECT].YPBP R/RGB terminal (BNC)*1*3IN : This is the YPB PR/RGB signal input terminal.OUT : This is the input signal through-out terminal.SYNC/HD, VD terminal (BNC) *2IN : This is the input terminal for external synchronizing SYNC/HD, VD signals.OUT : This is the input signal through-out terminal.• When using RGB signals from a PC, connect the horizontal synchronizing signal to the SYNC/HD terminal,and the vertical synchronizing signal to the VD terminal.GPI input terminal (D-SUB 9-pin)External control is possible by using a GPI signal.RS232C terminal (D-SUB 9-pin)External control is possible by using an RS232 signal.HEADPHONES output connector (stereo mini-jack M3)Connect a pair of headphones to monitor the sound.• The sound volume and sound quality will depend on the headphones.*1 Unless a cable is connected to the OUT terminal, the IN terminal is automatically terminated at 75Ω.Since a connection to the OUT terminal releases the 75Ω termination of the unit, the level of the VIDEO signalinput to the unit may become too large depending on the connected device.*2 Unless a cable is connected to the OUT terminal, the IN terminal is automatically terminated at 1 kΩ. Making aconnection to the OUT terminal will automatically release the 1 kΩ termination.*3 When a device is connected to the OUT terminal, 1080P and PC input and other broadband signals may distortcharacter outlines and other details.Rear panel terminals11 1219131815 161714111213141516171819Controls and Their Functions (continued)