Panasonic BTLH2550E - LCD VIDEO MONITOR Operating Instructions Manual

Also see for BTLH2550E - LCD VIDEO MONITOR: Operating instructions

29Main Menu (continued)Underlined values indicate factory defaults.*1 When the monitor is shipped, settings for “USER1” - “USER5” are identical to “FACTORY.”*2 “H POSITION”, “V POSITION”, “PHASE” and “CLOCK” (J page 37) cannot be saved or loaded.SYSTEM CONFIGSub menu Settings DescriptionB.LIGHT/CONT. BACKLIGHTCONTRASTSelects function to be assigned to BACKLIGHT/CONT. in the picture/volume adjusting menu. Adjusts the BACKLIGHT. Adjusts the CONTRAST.BACKLIGHT 0 - 50 Adjusts the backlight when the B.LIGHT/CONT. submenu is set toCONTRAST.MENUPOSITIONCENTERLBRBRTLTPositions the on-screen menu. Center of the screen Left Bottom Right Bottom Right Top Left TopSTATUSDISPLAYOFF3SEC OFFCONTINUESets display state for input signal status (on-screen menu). Not displayed.<3SEC OFF> Displayed for 3 seconds after a status change. Displayed at all timesSETUP LOAD USER5*1*2USER4*1*2USER3*1*2USER2*1*2USER1*1*2FACTORYLoads saved factory defaults (FACTORY) or user data (USER1 - USER5).After loading user data, the screen displays the signal selected beforeuser data was loaded.SETUP SAVE USER5*2USER4*2USER3*2USER2*2USER1*2Up to 5 sets of user data can be saved (J page 20).They save menu settings and adjustments made in the picture/volumeadjusting menu (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT)except “SETUP SAVE/SETUP LOAD.”POWER ONSETUP USER5USER4USER3USER2USER1FACTORYLASTSelects the settings used when the power is turned on. Starts in the mode used when the power was last turned off. Starts up using the factory defaults. Starts up using USER registered settings.POWER SAVEMODE OFFONSets the power save mode Does not activate the POWER SAVE mode. The backlight dims when no signal (NO SIGNAL) is input for 60seconds or longer. Signal input or menu operation will return thebacklight to its normal brightness.CALIBRATION Connect a CA-210 color analyzer and use this submenu to make acalibration. It also returns calibration data to factory defaults. (J page 30,31)