9-8 Assembly of the LCDLCD Refrection SheetHolder Sheet Holder SheetLCD RefrectionSheetLCD RefrectionSheetPrism SheetLIGT GUIDEPANELLCDFRAME0~0.5mmInsert after attaching 1.Make the silver side inside.Insert into the inside the ribs.(4 places in total)To avoid deflection,do not attach 2 tooclose to the Frame.Positional Relation Chart for 1 and 2Avoid running over the rib.(both sides)(Running over causes moire.)Insert into the inside the Hooks.(both sides)LCD ModuleLight Shield Sheet ALight Shield Sheet ALight Shield Sheet ALightShieldSheet AAR SHEETMODULELCD FRAMELCDLCDNGOK0.5~0mm0.50~0mm0~0.3mmNotes for removing the Protection Films.*Remove it parallel to LCD.Protection FilmProtection Filmion-blowerion-blowerBefore reattaching the peeledProtection Film to the LCD,remove electricity.*Absolutely avoid anystress on FPC.Handle with care.Details for attachmentDo not bend in thearrow direction.Avoid running over AR SHEET.After removing the four sheets of theRelease Paper of the two-sided tapeon the LCD frame, then attach 1.Remove the Protection Films. (both sides)Peeled Laminate Film is electric-charged.Before reusing the Film, remove electricity.Safety Workingstatic electricity generation>When removing the back side (inside)Protection Film,keep the wind from theion-blower to the peeled side of LCD.Then remove the Film slowly spendingmore than five seconds, from LCD TABside on the left bottom toward along thearrow direction.