Panasonic CF-30FTSAZAM Service Manual

Also see for Toughbook CF-30F3SAZAM: Operating instructions Reference manual Specifications Brochure

Contents

7-177.2.7. Setting the Palm Top Cover Sheet, Palm Top Cover, Touch Pad Adhesion Seat, TouchPad SW Knob, LED PCB And SW LED PCB1. Set the SW LED PCB.2. Attach the Power LED Packing Sheet to the LED SpacerSheet.3. Attach the LEDX6 Spacer Sheet on the SW LED PCB.4. Fix the SW LED PCB using the Screw. 5. Attach the PW LED Sheet.6. Pass the Cable of LED PCB through the hole 1 on the TopCabinet, then set the LED PCB.7. Attach the LES Spacer Sheet on the LED PCB.8. Set the touch Pad SW Knob In and Touch Pad SW Knob9. Attach the TP Bottom Tape to the Touch Pad.10. Pass the Cables of the Touch Pad through the hole 2 on theTop Cabinet, set the touch Pad.11. Attach the Touch Pad Adhesion Seat.12. Fix the Palm Top Cover using the 5 Screws. No1 toNo513. Attach the Palm Top Cover Sheet.Note:Tighten the Screws in the numbered order (No1 to No5).Screws : DRQT26+D4NLTScrews : DRQT26+E3FNL■ Preparation of SW LED FPCPalm Top Cover Sheet

Palm Top CoverPW LED SheetTouch Pad Adhesion SeatTouch PadLED PCB Touch Pad SW KnobTouch PadSW Knob InPW LEDPCBSW LEDPCBNo.4No.2No.5No.3No.1Hole 1Hole 20.5 0.51 1Attach the TapeAttach the Sheet* Notes:1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2Use a pinset.White Full Line : Mountain FoldAttach it not to overlap the SW leg.Flex Notch Standard 0 1White Dotted Line : Valley FoldSW-LED FPC Ass'y