14Digitizer / Multi Touch OperationThe following operations may not be possible depending on the application program being used. Change the settings for the screenz When needed, the screen settings can be configured using the following procedure.A To Display [Pen and Touch] screen.Click on the notification area and click . And then click [Customize yourflicks settings].When is not displayed:Click (Start) - [Control Panel] - [Hardware and Sound] - [Pen and Touch],and add the check mark in [Display flicks icon in the notification area] in[Flicks].B Make necessary changes and click [OK].CAUTIONz If a change is made to the display resolution, or the cursor cannot be pointed correctly with the digitizer pen, be sure tocalibrate the screen. (Î page 15)z When mouse drivers are installed (e.g., IntelliMouse), the screen function may not be used.z When the operation of panning (only the internal LCD) is performed while the display resolution is set higher than theresolution of the internal LCD, the screen function will not work properly.z Even when only an external display is in use, the cursor will move on the external display if the surface of the internal LCD istouched when the screen driver is active. Therefore, do not touch the internal LCD when only an external display is in use.z The screen function does not work in the Setup Utility.z The screen function does not work in the “Full Screen” of [Command Prompt].Functions OperationZoom in, zoom out Use two fingers to touch the image or text you want to zoom in or out on, and drawyour fingers apart to zoom in and together to zoom out.Rotate Use two fingers to touch the image or text, and use one finger as the center ofrotation and the other finger to rotate.Windows 7Windows XP