Panasonic CF-W2 Series XP Operating Instructions Manual

Also see for CF-W2 Series: User guide Operating instructions Operating instructions Operating instructions Operating instructions

Dealing with Problems (Summary)52TroubleshootingUnable to automatically enterstandby or hibernation modez If a peripheral is connected to the computer, disconnect the devicez When the internal LCD is closed, the computer may not enter standby orhibernation mode. In order to activate standby or hibernation automaticallywhile using the computer with the internal LCD closed, set [Touch Pad] to[Disable] in the [Main] menu of the Setup Utility.z If there is a disk in the DVD-ROM & CD-R/RW drive that has been formattedusing B’s CLiP, the computer will not enter standby or hibernation mode.Remove the disk.The computer does not resume z Did you disconnect the AC adaptor or the battery pack while the computerwas in standby mode? If the computer's power supply is disconnected whilethe computer is in standby mode all unsaved data will be lost.z Did you slide the power switch and hold it for four seconds or more? If so,the power will be turned off forcibly. In this case, all unsaved data will belost.Battery IndicatorThe red indicator is lit z The battery level is very low (the charge is approx. 9% or less).z Connect the AC adaptor. You can use the computer when the indicator lightis orange. If you do not have an AC adaptor, save your data and power offyour computer. After replacing the battery pack with a fully charged one,turn your computer on again.The red indicator blinks z Quickly save your data and power off your computer. Disconnect the ACadaptor and remove the battery pack, then connect them again. If the prob-lem persists, contact your technical support office. The battery pack orcharging circuit may be defective.The orange indicator blinks z Battery cannot be recharged temporarily because the internal temperatureof the battery pack is beyond the acceptable temperature range for recharg-ing. Once the allowable range requirement is satisfied, charging beginsautomatically. Your computer can be used normally in this state.Onscreen Reference ManualThe Reference Manual is not dis-playedz Is Adobe Reader installed?If you have uninstalled Adobe Reader, install using the following proce-dures.A Log on to Windows with the administrator authority.B Click [start] - [Run], input [c:\util\reader\AdbeRdr60_enu_full.exe],then click [OK].Install Adobe Reader by following the instructions on the screen.C Update Adobe Reader to its latest version.If your computer is connected to the Internet, start up AdobeReader and click [Help] - [Update].If your computer is not connected to the Internet, click [start] -[Run], input [c:\util\reader\Acro-Reader_6.0.2_Update.exe], thenclick [OK].Disk OperationsIf the DVD-ROM & CD-R/RW drivevibrates excessively or is noisyz Is the disk bent or labeled?z Check to see if the disk is inserted correctly, and it is in good condition. If thedisk is good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in theSetup Utility (Î page 33 ).z When writing to CD-R/RW using B's Recorder, you can minimize vibrationwhile writing by setting the writing speed at [8x] or less.Standby/Hibernation Function