Panasonic CQ-C8100N Operating Instructions Manual

Contents

Panasonic CQ-C8100N Operating Instructions Manual Manual pdf 5 page image

English98Preparationweqq Pull out the batterycase while pushing thetab.w Put a battery in thecase with (+)-side fac-ing up.e Put the case back.Battery Notes¡Remove and dispose of an old battery immediately.¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)(Included)Battery Life: Approximately 6 months under normaluse (at room temperature)¡ Do not disassemble or short the battery. Do not throwa battery into a fire.¡ Keep batteries away from children to avoid the risk ofaccidents.¡ Follow local regulations when disposing of batteries.OFFACCIGNFor a ACC-equipped car, select ON. (a page 31) Thefollowing functions are available. (default: off)¡ The power is turned on automatically when insertinga disc or magazine.¡ The clock can be displayed even if the power is off.(a page 14)¡ After the security function (a page 31) is set to ON,the function works when turning the ignition key toOFF.Caution: Improper use of batteries may causeoverheating, an explosion or ignition, resulting ininjury or a fire.Caution:Be sure to select OFF when your car has noACC position in the ignition switch. Failureto do this could cause the battery to godead.Notes:¡ Adjust the clock when “NO CT” appears on the dis-play.¡ When a broadcast of FM Radio Data System isreceived, the clock is put right automatically by theClock Time service. (a page 18)1 Press [MENU] to display the menu dis-play.For using the remote control, hold down [MENU]for 2 sec. or more.2 Press []] or [[] to display the DIS-PLAY menu.3 Press [{] to select “CLOCK ADJ”.4 Press [BAND] (SET) to confirm the dis-play.5 Adjust the setting value.[[]: Adjusting minutes[]]: Adjusting hours[}]: Forward[{]: Backward6 Press [BAND] (SET).7 Press [MENU] to confirm the adjust-ment.For using the remote control, hold down [MENU]for 2 sec. or more.The demonstration message appears for first use.1 Press [SOURCE] (PWR).The demonstration screen appears.2 Press [DISP] (Display).The demonstration screen is cancelled, and no moreappears.Note:If you would like to turn on the power and make thedemonstration message appear, hold down [SOURCE](PWR: Power) for 4 sec. or more. (at ACC on)You may need to set the following depending on thedevices to be connected.Using Subwoofer¡ Subwoofer level adjustment (a page 30)¡ Subwoofer low pass filter (a page 30)The following functions are activated when the SecurityFunction is ON. (a page 31)¡ The security indicator lights up when removing theface plate.¡ The alarm sounds and the message appears on thescreen to warn you to remove the face plate at poweroff.Note: After the ACC setting is set to on, these functionswork when turning the main power off. (a page 31)Security IndicatorCQ-C8300NBANDPreparationFirst Time Power On(DEMONSTRATION)Battery into Remote ControlACC SettingSecurity FunctionSettingOther SettingsClock adjustment BAND