Panasonic CQ-VAD9200U Operating Instructions Manual

Also see for CQVAD9200U - CAR A/V DVD NAV: Operating instructions

Panasonic CQ-VAD9200U Operating Instructions Manual Manual pdf 65 page image

¡Use with 12 volt DC negative ground car. This unit isonly for use with a 12 volt DC negative ground car. Itcannot be used in large trucks or diesel cars which are24 volt DC cars. If it is used in the wrong type of car, itmay cause a fire or an accident.❏ Required ToolsYou’ll need a screwdriver and the following:❏ Dashboard Specifications❏ Identify All LeadsThe first step in installation is to identify all the car wiresyou’ll use when hooking up your LCD monitor.As you identify each wire, we suggest that you label itusing masking tape and a permanent marker. This willhelp avoid confusion when making connections later.Note: Do not connect the power connector to the displayunit until you have made all connections. If there are noplastic caps on the hooking wires, insulate all exposedleads with electrical tape until you are ready to use them.Identify the leads in the following order.12 V DCTest BulbElectricalTapeSide-CutPliers69CQ-VAD9200U60ENGLISH❏ Before InstallationWarning¡Do not install the monitor in a location whichobstructs driving, visibility or which is prohibited byapplicable laws and regulations. If the monitor isinstalled in a location which obstructs forward visibilityor operation of the air bag or other safety equipment orwhich interferes with operation of the car, it may causean accident.¡Never use bolts or nuts from the car's safety devices forinstallation. If bolts or nuts from the steering wheel,brakes or other safety devices are used for installationof the monitor, it may cause an accident.¡Attach the wires correctly. If the wiring is not correctlyperformed, it may cause a fire or an accident. In particu-lar, be sure to run and secure the lead wire so that itdoes not get tangled with a screw or the moving portionof a seat rail.❏ Installation Hardware (For Wiring)Before you begin installation, look for the following itemswhich are packed with your unit.¡Warranty Card …… Fill this out promptly.¡Panasonic Servicenter for Service Directory ……Keep for future reference in case the product needsservicing.¡Installation Hardware …… Needed for installation.Cautions:¡Use the specified fuse. Be sure to always use thespecified fuse. If a fuse other than the specified fuseis used, it may cause a fire or an accident.¡Do not damage the cord by pinching or pulling it. Donot pull or damage the cord. If the cord is not treatedproperly, it will short out or be severed and maycause a fire or an accident.QtyDiagramItemNo.Power Connector(for hide-away unit)Clip ConnectorPower Connector(for display unit)@6 1@7 Reverse Extension Cord(for rear view camera) 1@8 1#0 Optical Fiber Cable 1#1 1Ground Lead#2 1Radio Antenna ExtensionCord#3 1Display Unit / Hide-away UnitConnecting Cord@9 1#4 Center Speaker Lead 1#5 Center Speaker ExtensionLead 1THICKNESSMIN. 3/16" (4.75 mm)MAX. 7/32" (5.56 mm)2-3/32" (53 mm)7-5/32" (182 mm)