Panasonic CQ-VAD9200U Operating Instructions Manual

Also see for CQVAD9200U - CAR A/V DVD NAV: Operating instructions

Panasonic CQ-VAD9200U Operating Instructions Manual Manual pdf 67 page image

71CQ-VAD9200U62ENGLISH¡Disconnect the cable from the negative (–) battery termi-nal (see caution at right).¡Unit should be installed in a horizontal position with thefront end up at a convenient angle, but not more than30°.less than 30°❏ PrecautionsThis unit should be professionally installed. In case of diffi-culty, please consult with your nearest professionalinstaller.1. This unit only operates in a 12-volt DC negative groundsystem.2. Follow the electrical connections carefully (a page 78-85). Failure to do so may result in damage to the unit.3. Connect the power lead after all other connections aremade.4. Be sure to connect the battery lead (yellow) to the posi-tive terminal (+) of the battery or fuse block (BAT) termi-nal.5. Insulate all exposed wires to prevent short circuiting.6. Secure all loose wires after installing the unit.7. Please carefully read the operating and installationinstructions of the respective equipment before connect-ing it to this unit.❏ Transportation bracket removalBe sure to remove the transportation brackets before use (installation).Use Binding-Head Screws (M5 x 6 mm) for installation. (a page 74)Be careful not to lose these Binding-Head Screws.Display UnitBinding-HeadScrews(M5 x 6 mm)Binding-HeadScrews(M5 x 6 mm)TransportationBracketTransportationBracketCautions:¡We strongly recommend that you wear gloves forinstallation work to protect yourself from injuries.¡When bending the mounting tab of the mounting col-lar with a screwdriver, be careful not to injure yourhands and fingers.Caution: Please follow the laws and regulations ofyour state, province or country for installation of theunit.Caution: Do not disconnect the battery terminals of acar with trip or navigational computer since all user set-tings stored in memory will be lost. Instead take extracare with installing the unit to prevent shorts.❏ Final InstallationLead ConnectionsConnect all wires, making sure that each connection isinsulated and secure. Bundle all loose wires and fastenthem with tape so they will not fall down later. Now insertthe LCD monitor into the mounting collar.Congratulations! After making a few final checks, you’reready to enjoy your new LCD monitor.❏ Final Checks1. Make sure that all wires are properly connected andinsulated.2. Make sure that the LCD monitor is securely held inthe mounting collar.3. Turn on the ignition to check the unit for properoperation.If you have difficulties, consult your nearest authorized pro-fessional installer for assistance.