Panasonic CQ-VD7003U Operating Instructions Manual

Also see for CQ-VD7003U: Operation instructions Installation guide

Contents

Panasonic CQ-VD7003U Operating Instructions Manual Manual pdf 10 page image

23Lithium battery(CR2025: supplied)Battery case910 CQ-VD7003UEnglish PreparationYou may need to set the following depending on thedevices to be connected.Subwoofer¡Execute and . (a page 36)Other speakers¡Execute . (a page 36)AV1/AV2 (Camcorder,VCR, etc.)¡Adjust . (a page 37)SOURCE LEVELSP SETUPSP LEVELSP SETUPRemote Control UnitSettingsWarning¡When you connect external devices to AV1-IN/AV2-IN (AV1/AV2), be sure to connect the sidebrake connection lead (aInstallation Instructions).Warning¡Keep batteries away from children to avoid the riskof accidents. If an infant ingests a battery, pleaseseek immediate medical attention.Caution¡Remove and dispose of an old battery immediately.¡Do not disassemble, heat or short a battery. Do notthrow a battery into a fire or water.¡Follow local regulations when disposing of a battery.¡Improper use of a battery may cause overheating, anexplosion or ignition, resulting in injury or a fire.Note:¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)Battery Life: Approximately 6 months under normaluse (at room temperature)Battery Replacementq Remove the battery holder with the remote controlunit placed on a flat surface.q Stick your thumbnail into the groove and push theholder in the direction of the arrow at the sametime.w Pull it out in the direction of the arrow using atough pointed object.Before Initial UsePull the insulation film out fromthe backside of the remote con-trol gently.w Put a battery in the case with (+)-side facing up.e Put the case back.Back sideTough pointed objectPlease refer to the separate “System UpgradeGuidebook” for how to operate this unit when option-al devices are connected.(user settings)( a page 32)display unit, clock, ID code, memory clear, other(screen settings)(a page 34)dimmer, picture(audio settings)(a page 34)sound setup, graphic equalizer, CS Auto, speaker setup,speaker level, time alignment, source level, cross over(DVD settings)(a page 38)language, display, pro logic, down mix, dynamic rangecompression, multiple channel(AV-IN/OUT settings)(a page 39)source skip(radio settings)(a page 40)FM set up, AM set upNote:¡Refer to “Settings” (a page 30) for further informa-tion about operations, settings, and others of themenu screen.RADIOINPUT/OUTPUTDVDAUDIOSCREENUSER