Panasonic CQ-VD7003U Operating Instructions Manual

Also see for CQ-VD7003U: Operation instructions Installation guide

Contents

Panasonic CQ-VD7003U Operating Instructions Manual Manual pdf 32 page image

3132 CQ-VD7003UEnglishID-CODEID Code SettingPrior to operating this unit, it is advisable to assign a 4-digit ID code for security. Once the ID code has been set,the unit cannot be operated if the main power supply isdisconnected then re-connected. It is electronically lockedso that a thief cannot use the stolen unit unless that per-son knows the code you have set.The ID code operation must be performed only by theperson to whom the unit belongs.Generally, it is not necessary to enter the ID code eachtime when using the unit if it has not been disconnectedfrom the main power supply (car battery).to 4 digits numeric codedefault: noneHow to set your ID code (for the first time)q Enter an 4 digit ID code.w Enter the same 4 digit ID code again.How to change your ID codeq Enter the preset (old) 4 digit ID code. If the wrong IDcode is entered, a new ID code cannot be registered.w Enter a new 4 digit ID code.e Enter the new 4 digit ID code again.How to cancel the known ID codeq Enter the preset (old) 4 digit ID code. If the wrong IDcode is entered, it is not possible to cancel the ID codefunction.w Touch and hold until “COMPLETED!” is dis-played. The ID code cancelling procedure is completed.The unit now works without an ID code.Note:¡Should your unit ever require service, cancel your IDcode before sending for repair.¡The ID code setting cannot be eliminated even by thememory clear function.¡The inputted code is not displayed for your security.90Caution¡Record your registered ID code and keep it in asecure location. (Fill in the ID code memo (apage 46).) If you forget it, you will be unable to usethe unit. In case you forget the ID code, pleaseconsult your nearest Panasonic Servicenter.Settings (continued)DISPLAY UNITDisplay adjustment(Tilt angle adjustment)TILT: the monitor is opened automaticallywhen turning ON ACC.: the monitor is not opened automatically.default:Note:¡The monitor position setting menu can also be dis-played by pressing the [TILT] button on the displayunit for more than 2 seconds. (a page 17)MANUALMANUALAUTO(Monitor setting when power on)OPEN/CLOSE54321default: 5RADIOINPUT/OUTPUTDVDAUDIOSCREENUSERCLOCKClock setting: clock display OFF: clock display ON (“12:00” is displayedbefore adjusting the clock.)default:: moves back one hour: forward one hour: moves back one minute: forward one minuteNote:¡To start the clock, touch/press /[SRC].¡Set the Daylight Saving Time manually.default: HOUR ADJUST: 12MINUTE ADJUST: 0[](Minute adjustment)MINUTE ADJUST[](Hour adjustment)HOUR ADJUSTOFFONOFF(Clock display)DISPLAY1 5