Panasonic CS-TE12DKE Service Manual

Also see for CS-TE12DKE: Operating instructions

Contents

Panasonic CS-TE12DKE Service Manual Manual pdf 66 page image

13.4.1.1. Removal of the Front Panel1. Push the Front Panel up toward upper side from thehorizontal line a little by hand.Fig. 12. Pull it out by pressing each arm located on left and rightsides toward outside.Fig. 2Note for Reassembly:Put each axis into Bearing Ass’y up to the bottom oneside by one while keeping the Front Panel horizontal.Fig. 3Note for Reassembly:Insert protruding parts on the reverse side of the panel(both left and right sides), for right side, between thePCB Control Box the Open/Close Motor, and for leftside, into the left side of the Heat Exchangerrespectively.Fig. 413.4.1.2. Removal of Front Grille1. Remove the Front Panel according to the item 13.5.1.1.2. Keep the Vertical Louver horizontal.3. Pull the Screw Caps (two in left and right sides) toward thefront side and unscrew the screws inside (one each left andright), and finally unscrew the screw on the right side of theFront Grille (one).Fig. 5Note for Disassembly:Removing the Front Panel in advance before removal ofAir Filters (two) can make reassembly of the Grille easy.4. Remove the Front Grille to upside by holding the lower partup a little.Note for Disassembly:There are three hooks on the top. Holding the Grille upwhile holding these hooks down makes its removaleasy. Be careful of the hooks that might be hard.Fig. 6Note for Reassembly:Put the Grille back securely until you hear click soundof all the hooks (three) on the top. Or, it may causebreakdown such as “Front Panel does not open” due toout of gear of the Front Panel Open/Close Motor.13.4. DISASSEMBLY OF PARTS13.4.1. Disassembly of Indoor Unit66CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE