Panasonic CS-V18DKE Service Manual

Contents

Panasonic CS-V18DKE Service Manual Manual pdf 58 page image

• When the batteries are inserted for the first time or thebatteries are replaced, you may notice the indications atremote control’s display screen blink continuously and notfunctionable. If this condition happens, try to reset theremote control by pushing the reset terminal with a pointingdevice.• You may also do the reset to erase the setting at remotecontrol and restore back the default setting.12.4. Remote Control Reset12.5. Auto OFF/ON Button• The “Auto OFF/ON Button” (behind the front grille) is used to operate the air conditioner if remote control is misplaced ormulfunctioning.• Forced cooling operation is possible by pressing the “Auto OFF/ON Button” for more than 5s where “beep” sound is heard thenrelease the button.• User able to select remote control transmission code and toggle remote control signal receiving sound under various settingmode.• To enter various setting mode:− Press the “Auto OFF/ON Button” continuously for 5s (“beep” sound is heard) and release.− Within 20s, press the “Auto OFF/ON Button” continuously for 5s again (2 “beep” sound is heard) and release.− Various setting mode has limit up to 20s. Then return to normal operation.12.5.1. Toggle Remote Control Signal Receiving Sound• Under various setting mode, press the “Auto OFF/ON Button” to toggle the remote control sound.− Short “beep”: Turn ON remote control signal receiving sound.− Long “beep”: Turn OFF remote control signal receiving sound.• After “Auto OFF/ON Button” is pressed, the 20s counter for various setting mode is restarted.12.5.2. Select Remote Control Transmission Code• There are 4 types of remote control transmission code could be selected and stored in EEPROM of indoor unit. The indoor unitwill only operate when received signal with same transmission code from remote control. This could prevent signal interferencewhen there are 2 or more indoor unit installed nearby together.• To change remote control transmission code, short or open jumpers at the remote control printed circuit board.• Under various setting mode, after select the transmission code combination of remote control, press any button of remotecontrol to transmit a signal to indoor unit. The transmission code will be stored in EEPROM.• After signal is received, the various setting mode is cancelled and return to normal operation.58CS-V18DKE CU-V18DKE / CS-V24DKE CU-V24DKE