Panasonic CU-J50DBE8 Service Manual

Also see for CS-F24DTE5: Service manual Operating instructions Operating instructions Service manual

Contents

Panasonic CU-J50DBE8 Service Manual Manual pdf 52 page image

521. Insert the hanging bracket fastening bolts and both sides of the unit into the hanging brackets, and slide the unit to the rear.Fasten the bolts.2. Tighten the slip prevention screws (M5) for brackets to prevent the unit from shifting.3. To ensure correct drainage, after hanging the unit, use a level gauge to check the installation angle.10.4.4. Refrigerant pipingRefrigerant is charged to the outdoor unit. For details, see the manual for installation work of outdoor unit.(Additional charging,etc.)1. Brazing for piping.a. Execute brazing before tightening the flare nut.b. Brazing must be executed while blowing nitrogen gas.(This prevents generation of oxidized scale in copper pipe.)2. When there is a lot of brazing for long piping, install a strainer at the midway of the piping.(The strainer is locally supplied.)3. Use clean copper pipe with inner wall surface free from mist and dust. Blow nitrogen gas or air to blow off dust in the pipebefore connection.4. Form the piping according to its routing. Avoid bending and bending back the same piping point more than three times.(This will result in hardening of the pipe).5. After deforming the pipe, align centers of the union fitting of the indoor unit and the piping and tighten them firmly withwrenches.6. Connect pipe to the service valve or ball valve which is located below the outdoor unit.7. After completed the piping connection, be sure to check if there is gas leakage in indoor and outdoor connection.• Confirm the red mark of the union (thin side) is always at lower direction after connecting piping.Vacuum dryingAfter completing the piping connection, execute vacuum drying for the connecting piping and the indoor unit.The vacuum drying must be carried out by using the service ports of both the liquid and gas side valves.Installing the unitCAUTION Use two wrenches and tighten with regular torque.Flare nut fastening torque N.m (kgf.cm)ø6.35 mm 18 (180) ø15.88 mm 65 (660)ø9.52 mm 42 (430) ø19.05 mm 100 (1020)ø12.7 mm 55 (560)Liquid side piping Gas side pipingø9.52 mm ø15.88 mm