Panasonic CY-VHD9500U Operating Instructions Manual

Also see for CY-VHD9500U: Instalation guide Operating instructions Installation instructions

Panasonic CY-VHD9500U Operating Instructions Manual Manual pdf 5 page image

8 CY-VHD9500UENGLISHCY-VHD9500U 9ENGLISHSafety Information (continued)Cautions At the time of installationBefore connecting the product withanother device, consult the operatinginstructions of the device concerned toensure that the product and device willbe connected properly.Incorrect connections may causeaccidents and/or malfunctioning.Install the monitor in a position whereit will not hit anybody’s head when itopens and closes.Failure to heed this caution mayresult in an accident and/or injury.If an RCA or similar cord is to beconnected to the product, adjust itsposition and length so that it will notbecome entangled or come into contactwith your body. After use, be absolutelysure to disconnect it from the product.Failure to heed this caution mayresult in an accident and/or injury.Take care not to injure your fingers withthe power drill or other tool you areusing. Also take care not to damage thewiring near the ceiling panel.Failure to heed this caution mayresult in an accident, injury and/ormalfunctioning.Cautions At the time of operation or installationCaution for replacing the bulb of the dome lightAsk a qualified specialist to do this job.While you are replacing a bulb, be absolutely sure to keep the dome light switch at OFF.Otherwise, you may burn yourself.The bulb is very hot to the touch while it is lighted and immediately after it has gone off.Before attempting to replace it, turn the dome light switch off, wait several minutes andthen check that it cooled off.Use a bulb with the specified ratings (12 V/5 W). Do not use any other bulb.Gripping the bulb with too much force may break it. Wear fingerstalls or use some otheranti-slip method when replacing it.Do not damage the cords.Wire breaks and short circuits cancause electrical shock or fi re.Run the cords so that they do not gettangled in the moving parts (such asthe seat rails), screws or car body.Do not damage, pull too hard, fold,twist, or work on the cords. Donot place the cords near heatingappliances or put heavy objects onthe cords.ForbiddenTake care that the wiring is not pinchedor caught by the base plate attached tothe roof or any other parts.As you cut the headliner, take carenot to cut your fi ngers. Also take carenot to damage any other areas of theheadliner.Failure to heed this caution mayresult in an accident and/or injury.Cautions At the time of installationBefore installing the unit, be absolutelysure to check that the screws do notmake any contact with the ceilingpanel.If some space is required betweenthe base plate and the unit, attachand adjust the under cover. Fordetails on installing the under cover,consult your dealer.Failure to heed this caution mayresult in an accident and/or injury.Do not poke your fi ngers between theceiling and this product.Failure to heed this cautionmay result in an injury and/ormalfunctioning of the product.ForbiddenWear gloves for installation work toprotect yourself from injuries.Failure to heed this caution mayresult in an accident and/or injury.Wear goggles or protective eyewear toshield your eyes from airborne metalparticles during drilling.Failure to heed this caution mayresult in an accident and/or injury.NO WARRANTYPanasonic shall have no liability for reduction in safety or any accident caused by installing thisproduct. We shall not guarantee any auto parts damaged during installation.Caution for electrical connections:To prevent damage to the unit, be sure to follow the connection diagram.Do not connect the power connector to the unit until the wiring is completed.When connecting stripped wires, be sure to wrap them securely with electrical tape toprevent shorts.Bundle all cables and keep cable terminals free from touching any metal parts.