Panasonic CY-VHD9500U Operating Instructions Manual

Also see for CY-VHD9500U: Instalation guide Operating instructions Installation instructions

Panasonic CY-VHD9500U Operating Instructions Manual Manual pdf 6 page image

10 CY-VHD9500UENGLISHCY-VHD9500U 11ENGLISHProtect Disc and SD memory Card≥ When you leave the car, be sure to eject thedisc/SD memory card from this unit and bring itout.When not Using the Product≥ Lock the monitor in the fully closed position.≥ If the display unit cannot be locked, be absolutelysure to consult your dealer and remedy thesituation.Dimmer Sensor≥ This unit automatically adjusts the screenbrightness in accordance with the brightness ofits surroundings. However, the dimmer sensormay not function properly if it is exposed directlyto sunlight or other strong sources of light.When Listening with IR WirelessHeadphones≥ Even if your headphones are the open-air typedesigned to let you hear outside sounds, do notturn up the volume so high that you can not hearwhat is around you.≥ Sound can be deceiving. Over time your hearingcomfort level adapts to higher volumes of sound.So what sounds normal can actually be loud andharmful to your hearing. Guard against this bysetting your equipment at a safe level BEFOREyour hearing adapts.To establish a safe level:• Start your volume control at a low setting.• Slowly increase the sound until you can hear itcomfortably and clearly, and without distortion.≥ Once you have established a comfortable soundlevel, set the dial and leave it there.≥ Do not attempt to adjust the size while wearingheadphones. (You may find that your hair is pulledas it becomes entwined with the headphones.)≥ There may be breaks in the sound or noise maybe heard if the headphones are used at a distancefrom this unit (display) or if obstructions blockthe infrared rays. These problems are caused bycharacteristics which are inherent in infrared rays,and thus are not indicative of any malfunctioning.≥ Make sure that the infrared sensor window is notcovered by your hands or hair.≥ Since these headphones use infrared rays foroperation, avoid using them in direct sunlight.≥ When playing DVD video recordings and listeningto their sound through IR wireless headphones,the sound may be heard at a low level evenafter the volume of the IR wireless headphoneshas been turned up. In a case like this, stopplaying the disc, and then change the DRC(Dynamic Range Compression) setting amongthe DVD video settings (page 82) to “Minimum”or “Standard”. However, depending on a disc’s format and content (music DVD, etc.), youmay feel that the sound is not being reproducedproperly. If this is the case, keep the DRC settingat OFF.≥ When listening to sound through headphones,the volume level is a little lower comparedwith listening to sound which is delivered fromspeakers through an external device.Find the model number and serial number on either the back or bottom of the unit. Please record them in thespace below and retain this booklet as a permanent record of your purchase to help with identifi cation in caseof theft.MODEL NUMBER CY-VHD9500USERIAL NUMBERDATE PURCHASEDFROMExemption from Liability≥ The manufacturer will not be liable in any way forany incidental damages (such as loss of businessincome or changes or loss of memory data)which may result from the use of or failure to usethis product.≥ The terms and conditions of the warranty whichaccompanies the product do not apply when theproduct is operated in a vehicle which is used forbusiness purposes (such as a bus, taxi cab orcommercial vehicle).≥ No guarantees can be made for the numericalvalues which have been set in the product whenthose values have been changed as a result ofmisuse of the product by the user or any thirdparty or of the effects of static or electrical noiseor of malfunctioning or repairs.≥ The manufacturer will not be liable in any way forthe loss, destruction or erasure of SD card datawhich is a result of improper handling.Liquid Crystal Panel≥ Storage temperature range: `4 °F to 176 °F(`20 °C to 80 °C)When the liquid crystal panel reaches hightemperatures or low temperatures, chemicalchanges occur within the liquid crystal panelwhich may cause malfunctions.≥ Do not strongly impact the liquid crystal panel.≥ When the temperature is very cold or very hot,the image may not appear clearly or may moveslowly. Also, movement of the image may seemto be out of synchronization or the image qualitymay decline in such environments. Note that thisis not a malfunction or problem.Usage temperature range: 32 °F to 104 °F(0 °C to 40 °C)≥ There may be red spots, blue spots and greenspots on the panel surface. This is a characteristicof liquid crystal panels and is not a problem. Theliquid crystal panel is built with very high precisiontechnology and has at least 99.99 % effective imagepixels. Be aware that on 0.01 % of the panel theremay be missing pixels or constantly light pixels.≥ In order to protect the liquid crystal panel, keep itout of direct sunlight while the unit is not in use.≥ Sudden changes in the temperature inside the carsuch as those which occur immediately after thecar’s air conditioner or heater has been turned onmay cause the inside of the liquid crystal panelto cloud over due to water vapor or it may causecondensation (droplets of water) to form and, asa result, the panel may not work properly. Do notuse the unit while these symptoms are in evidencebut leave the unit standing for about an hour, andthen resume or start use.SpotsNotes on UseCAUTION:T H I S P R O D U C T I S A C L A S S I L A S E RPRODUCT.USE OF CONTROLS OR ADJUSTMENTS ORPERFORMANCE OF PROCEDURES OTHERTHAN THOSE SPECIFIED HEREIN MAY RESULTIN HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIRYOURSELF. REFER SERVICING TO QUALIFIEDPERSONNEL.The following applies only in the U.S.A.NOTICE:This product has a fl uorescent lamp thatcontains a small amount of mercury. Italso contains lead in some components.Disposal of these materials may be regulatedin your community due to environmentalconsiderations.For disposal or recycling informationplease contact your local authorities,or the Electronics Industries Alliance: