Panasonic CZ-64ESMC3 Installation Instructions Manual

Also see for CZ-64ESMC3: Operating instructions Quick reference Installation instructions

19(EN)Controller setup1 Press and hold the 3 buttons for4 seconds or more simultaneously., , ►2 Select the item to set.▲ ▼ →3 Set.▲ ▼ → →*Factory defaultItemcode Set contents Set data01Main/Sub setting Set "Main" when using a single unit of the system controller. Set "Sub" when using in combination of a central control device such as intelligent controller. When using multiple system controllers in a case other than , set "Main"only for one unit. In zone mode, set "Main" for one unit in each zone.It is recommended to set "Main" for the system controller whose item code03 "All/Zone mode" is set to "All mode".0000: Sub0001: Main*02System Controller address settingUp to 10 system controller (CZ-64ESMC3) can be connected on the inter-unit controlwiring. When installing more than one unit, assign self addresses to avoid duplication.• 0000: Address 1*• 0001 to 0009: Address2 to 1003All/Zone modeAll modeSets all the indoor units.Zone 1, Zone 2, Zone 3 and Zone 4 modeSets only the indoor units in any of the Zone 1, Zone 2, Zone 3 and Zone 4.Can control for each zone and each group.See "Number-of-controlled-units mode" as well.• 0000: All mode *• 0001: Zone 1 mode• 0002: Zone 2 mode• 0003: Zone 3 mode• 0004: Zone 4 mode04R/C prohibited settingSets Enable/Disable of the R/C prohibited setting function.When the item code 05 “Central control/Remote control mode” is set to"Remote control mode", this is disabled.• 0000: Disabling thesetting function set *• 0001: Disabling thesetting function not set05Central control/Remote control modeCentral control mode• Disabling the setting function can be used.Remote control mode• Disabling the setting function cannot be used.• The Prohibit R/C setting is disabled.See "Number-of-controlled-units mode" as well.• 0000: Central controlmode *• 0001: Remote controlmodeENGLISH