Panasonic DMR-BWT740 Operating Instructions Manual

Also see for DMR-BWT740: Operating instructions

Contents

Panasonic DMR-BWT740 Operating Instructions Manual Manual pdf 95 page image

TroubleshootingSQT0139 95The remote control does not work.• The remote control and main unit are usingdifferent codes. Change the code on the remotecontrol.• Software (firmware) is updating when “UPD/” is displaying on the unit’s display. Wait untilthe update is completed. (> 93)• The HOLD function is activated. (> 92)• Startup of this unit may be slower depending onthe TV settings.“0:00” is flashing on the unit’s display.• Set the clock. (> 76, 87)The clock does not display on the unit whenswitched to standby.• The clock does not display when “Unit’s Display”is set to “Automatic”. (> 83)Screen size is wrong.• Check the “TV Aspect” or “Aspect for 4:3 Video”.(> 83)• Adjust the aspect ratio setting on TV.• Adjust the aspect ratio setting on this unit.(> 92)• If you connect to 4:3 TV, set “HDMI VideoFormat” to “576p/480p”. (> 76, 83)• Check “Aspect for Recording” before recordingor file conversion. (> 76, 81)The black screen appears on the TV.• This phenomenon may occur, depending on theTV setting, when “Quick Start” is activated.Depending on the TV, this phenomenon may beprevented by reconnecting to a different HDMIinput terminal.TV reception is not displayed.• Broadcast signals are not output from this unit’sRF OUT terminal. Select “On” in “RF OUT( Aerial Signal )”. (> 76, 87)Picture does not appear with the HD qualityalthough HD setting was made.• The pictures are output with 576p/480pdepending on the title.The screen changes automatically.• If “Screen Saver” is set to “On”, the screen saverfunction will be activated when there is nooperation for 5 minutes or more. (> 83)There is a lot of image lag when playing video.• Set to “0” all items in the “Noise Reduction”.(> 75)• Set “Audio Delay”. (> 76, 82)Unit's displayPress and hold [OK] andthe indicated numberbutton at the same timefor more than 5 seconds.(> 87)Startup is slow.• Startup takes time in the following situations:- A disc is inserted.- The clock is not set.- Immediately after a power failure or the ACmains lead is connected.- When a BD-J application is executing.- When the “Quick Start” is not activated. (> 86)DisplaysTV screen and video