Panasonic DMR-E20K Operating Instructions Manual

Also see for Diga DMR-ES20: Operating instructions Setup guide Operating instructions Setup guide

RQT815211 Getting startedn If the clock is an hour slower or faster than theactual timeSelect “–1” or “+1” in “Adjust Time Zone” in the SETUP menu(Ô page 34).n If the unit couldn’t set the clock automaticallySet the time manually (Ô page 34, Set Clock Manually).n To start Plug-in Auto Tuning again (afterrelocation, for example)When the unit is on and stoppedPress and hold [1 CH] and [2 CH] on the main unit forabout five seconds.The unit turns off.Press [^ DVD POWER] to turn the unit on.1 Press [SETUP].2 Press [e, r] to select “Channel” andpress [q].3 Press [e, r] to select “Signal Source(RF IN)” and press [ENTER].4 Press [e, r] to select “Antenna” or“CableTV” and press [ENTER].5 Press [e, r] to select “Set ChannelsAutomatically” and press [ENTER].6 Press [ENTER].Auto Channel Setting starts. This takes a few minutes.7 Press [ENTER].To cancel partwayPress [RETURN].To exit the screenPress [SETUP].Add or delete channels if necessary channels are not set orunnecessary channels are set.1 Press the numbered buttons to selecta channel.• You can also use [1 2 CH] when you are going to delete achannel.2 Press [ADD/DLT].e.g., The channel is deleted.Signal source, channel caption, and VCR Plus+ guidechannel settings all revert to the default values when youperform the procedure below. Scheduled recording settingsare also cleared.If Plug-in Auto Tuning fails12Channel CaptionsCable TVChannelSETUPSetupDiscVideoAudioDisplayTV ScreenSignal Source (RF IN)Set Channels AutomaticallyPreset Channel CaptionsManual Channel CaptionsVCR Plus+ Ch. SettingSETUPSetupVideoAudioDisplayTV ScreenChannelSignal Source (RF IN)AntennaCableTVDiscENTERAdding and deleting channelsTVRECPAntenna Mode (Airwaves)e.g., 5: [0] Ô [5]15: [1] Ô [5]CableTV Mode (Cable)e.g., 5: [0] Ô [0] Ô [5]15: [0] Ô [1] Ô [5]115: [1] Ô [1] Ô [5]Unit’s displayChannel 15 Deleted